专业数字CCTV安全测试仪TFT-LCD显示器的圆顶相机

议价
加入意向| 型号。 | STEST-893(V) |
| 应用 | 室内,户外,监控,大屏幕工程,手机 |
| 特征 | LED背光显示屏,支持电视功能,UTP测试 |
| 类型 | TFT |
| 响应时间 | 为3ms |
| 接口类型 | HDMI |
| 电源电压 | 5V |
| 规范 | ce,fcc |
| HS编码 | 9031809090 |
| 屏幕尺寸 | 3.5英寸 |
| 长宽比 | 3.5英寸 |
| 最佳分辨率 | 480*320 |
| 宽屏 | 不是宽屏 |
| 3D | 不是3D |
| 尺寸 | 3.5英寸 |
| 商标 | eyevison |
| 起源 | 中国深圳 |
模型 | HVT-2623 / 2623T(六代) | |||
视频测试 | ||||
信号模式 | NTSC / PAL(自适应) | |||
显示 | 3.5寸数字TFT-LCD,480(RGB)×320分辨率 | |||
LCD调节 | 亮度,对比度,饱和度可调 | |||
视频输入/输出 | 1通道BNC输入和1通道输出输出utput | |||
视频 输出模式 | 1.0 Vp-p | |||
视频等级测试 | ||||
水平测试 | 以IRE或mV测量的视频信号 | |||
云台控制器 | ||||
通讯 | 支持RS232和RS485 | |||
云台协议 | 兼容30多种协议,如PELCO-D / P,三星, 松下,林林,雅安等 | |||
波特率 | 600,1200,2400,4800,9600,19200,57600,115200bps | |||
视频信号生成 | ||||
彩条发生器 | 输出一路PAL / NTSC彩条视频信号进行测试 或视频电缆(红色,绿色,蓝色,白色和黑色) | |||
UTP电缆测试仪 | ||||
UTP电缆测试 | 测试UTP电缆连接状态并显示在屏幕上。阅读 测试箱的编号。 | |||
DC12V 1A电源输出 | ||||
DC12V电源输出 | 输出DC12V1A相机电源 | |||
音频输入测试 | ||||
音频输入测试 | 测试前端的拾音器和其他音频设备 | |||
RS485数据分析 | ||||
数据监控 | 捕获并分析来自控制设备的命令数据 | |||
10倍缩放图像 | ||||
Image10x缩放 | 10倍缩放图像显示和视频输出 | |||
照片,录像,录像播放 | ||||
照片 | 快照并将当前图像保存为JPG文件 | |||
视频记录 | 视频记录和存储文件 | |||
录制播放 | 查看SD卡中的存储文件 | |||
端口闪烁 | ||||
端口闪烁 | 快速查找已连接的POE端口。 | |||
IP地址扫描,Link监视器,PING测试 | ||||
IP地址扫描 | 找出所连接的IP摄像机或其他网络设备的IP地址 很快。 | |||
链接监视器 | 检查IP地址是否被占用 | |||
PING测试 | 测试IP摄像机或其他网络设备的以太网端口是否工作 通常,并检查IP地址 | |||
电缆扫描(电线追踪器) | ||||
有线扫描 | 通过音频信号搜索电缆 | |||
Poe测试仪 | ||||
Poe测试仪 | 显示电源电压和电缆连接状态 | |||
数字多功能表 | ||||
AC / DC电压 | 0-660V自动/手动量程,最小分辨率为0.1mV | |||
AC / DC电流 | 660.0ua,6.600ma,66.00ma,660.0ma,10.00a | |||
抵抗性 | 660.0Ω,6.600kΩ,66.00kΩ,660.0kΩ,6.600MΩ,66.00MΩ | |||
电容 | 6.6nf〜66000uF,最小分辨率为1pf | |||
二极管 | 0〜2V正向电压,最小分辨率为1mV | |||
数据保持 | 保持并显示测量值 | |||
相对测量 | 显示相对功率值 | |||
连续性测试 | 如果电阻低于50Ω,内置蜂鸣器会发出声音 | |||
测试速度 | 3次/秒 | |||
数据范围 | -6600~+6600 | |||
视频电平表 | 仅适用于T型 | |||
PEAK视频信号电平,SYNC信号电平,COLOR BURST铬电平测量 | ||||
TDR电缆测试仪(仅适用于T型) | ||||
TDR电缆测试仪 | 准确测量BNC电缆,网线,控制电缆断点和 短路位置。 | |||
视觉故障定位器 | ||||
视觉 故障定位器 | 测试纤维的弯曲和断裂(SM和MM纤维) | |||
功率 | ||||
电源适配器 | 直流5v(1.5a) | |||
电池 | 内置3.7V锂聚合物电池,3000mAh | |||
充电 | 充电3-4小时后,工作时间为11小时 | |||
消费低 | 节能技术,电池图标实时显示 | |||
参数 | ||||
操作设置 | 英文/中文等语言OSD菜单 | |||
自动关闭 | 5-60(分钟) | |||
按键音 | 开关 | |||
一般 | ||||
工作温度 | -10ºC〜+50ºC〜+50ºCrdm;C~+50ºC | |||
工作湿度 | 30%~ 90% | |||
尺寸/重量 | 194mm x 112mm x 48mm / 540g | |||
| Model NO. | STest-893(V) |
| Application | Indoor, Outdoor, Surveillance, Big-Screen Project, Mobile Phone |
| Feature | LED Backlight Display, Support TV Function, UTP Test |
| Type | TFT |
| Response Time | 3ms |
| Interface Type | HDMI |
| Power Voltage | 5V |
| Specification | CE, FCC |
| HS Code | 9031809090 |
| Screen Size | 3.5 Inch |
| Aspect ratio | 3.5 Inch |
| Optimum Resolution | 480*320 |
| Widescreen | Not Widescreen |
| 3D | Not 3D |
| Size | 3.5 Inch |
| Trademark | EYEVISON |
| Origin | Shenzhen, China |
Model | HVT-2623/2623T(VI generation) | |||
Video Test | ||||
Signal mode | NTSC/PAL (Auto adapt) | |||
Display | 3.5 inch digital TFT-LCD ,480(RGB)x 320 resolution | |||
LCD adjustment | Brightness, Contrast, Saturation adjustable | |||
Video IN/OUT | 1 channel BNC Input & 1 channel Outpututpututput | |||
Video Output Mode | 1.0 Vp-p | |||
Video Level test | ||||
Level test | Video signals measured in IRE or mV | |||
PTZ controller | ||||
Communication | Support RS232 and RS485 | |||
PTZ Protocol | Compatible with more than 30 protocols such as PELCO-D/P, Samsung, Panasonic, Lilin, Yaan, etc. | |||
Baud Rate | 600,1200,2400,4800,9600,19200,57600,115200bps | |||
Video Signal Generation | ||||
Color bar generator | Output one channel PAL/NTSC color bar video signal for testing monitor or video cable.(red, green ,blue, white and black color ) | |||
UTP Cable tester | ||||
UTP cable test | Test UTP cable connection status and display in the screen. Read the number of the test box. | |||
DC12V 1A power output | ||||
DC12V power output | Output DC12V1A power for camera | |||
Audio input test | ||||
Audio input test | test the pickup and other audio equipments on the front-end | |||
RS485 data analysis | ||||
Data Monitor | Captures and analyzes the command data from controlling device | |||
10x Zoom Image | ||||
Image10x zoom | 10x zoom image display and video out | |||
Photograph, Video record, Record playback | ||||
Photograph | snapshot and save the current image as JPG file | |||
Video record | Video record and storage the file | |||
Record playback | To view the storage file in the SD card | |||
Port flicker | ||||
Port flicker | Find the connected POE port quickly. | |||
IP address scan, Link monitor, PING test | ||||
IP address scan | Find out the connected IP camera or the other network equipment IP address quickly. | |||
Link monitor | Check the IP address whether is occupied | |||
PING testing | Test IP camera or Ethernet port of the other network equipment whether work normally, and check the IP address | |||
Cable scan(Wire tracker) | ||||
Cable scan | Search the cable by the audio signal | |||
Poe tester | ||||
Poe tester | Display the power supply voltage and cable connection states | |||
Digital Multi meter | ||||
AC/DC Voltage | 0-660V auto/manual range, the min resolution is 0.1mV | |||
AC/DC current | 660.0uA , 6.600mA, 66.00mA , 660.0mA, 10.00A | |||
Resistance | 660.0Ω, 6.600kΩ, 66.00kΩ, 660.0kΩ, 6.600MΩ, 66.00MΩ | |||
Capacitance | 6.6nf~66000uF, the min resolution is 1pf | |||
Diode | 0~2V forward voltage, the min resolution is 1mV | |||
Data hold | Hold and display the measured value | |||
Relative measurement | Display the relative power value | |||
Continuity testing | Built-in buzzer will sound, if resistance is lower than 50 Ω | |||
Testing speed | 3 times/ seconds | |||
Data range | -6600~+6600 | |||
Video level meter | Only for T model | |||
PEAK video signal level, SYNC signal level, COLOR BURST chrome level measurement | ||||
TDR cable tester ( Only for T model ) | ||||
TDR cable tester | Accurately measure BNC cable, network cable, control cable break-point and short-circuits location. | |||
Visual fault locator | ||||
Visual fault locator | Test fiber's bending and breakage ( SM and MM fiber) | |||
POWER | ||||
Power Adapter | DC 5V(1.5A) | |||
Battery | Built-in 3.7V Lithium polymer battery ,3000mAh | |||
Rechargeable | After charging 3-4 hour, working time lasts 11 hours | |||
Low Consumption | Energy saving technology, the battery icon real-time display | |||
Parameter | ||||
Operation setting | English/Chinese and other languages OSD menu | |||
Auto off | 5-60 (mins) | |||
Key tone | On/Off | |||
General | ||||
Working Temperature | -10ºC ~+50ºC~+50ºCrdm;C~+50ºC | |||
Working Humidity | 30%~ 90% | |||
Dimension/Weight | 194mm x 112mm x 48mm / 540g | |||