3.5 Inch CCTV Tester for Analog CCTV Camera

3.5 Inch CCTV Tester for Analog CCTV Camera

3.5英寸CCTV测试仪模拟CCTV摄像机

议价

加入意向
型号。 HVT-2613
屏幕尺寸 3.5英寸
长宽比 3.5英寸
最佳分辨率 480*320
响应时间 为3ms
接口类型 HDMI
规范 ce,fcc
HS编码 9031809090
类型 TFT
应用 大屏幕项目,室内,室外
特征 LED背光显示屏,支持电视功能
宽屏 不是宽屏
3D 不是3D
商标 eyevison
起源 中国深圳

电缆连续性测试仪CCTV摄像机配件,带万用表的闭路电视摄像机测试仪
快速详细:
1.设备端口闪烁,通过发送特殊信号轻松查找连接的POE交换机端口,连接的POE端口将以特殊频率闪烁。
链接监视器检查设置IP地址是否被占用
TDR断点和短路测量(BNC电缆,网线等)
4. PTZ地址扫描,搜索PTZ摄像机的ID。
5.网络电缆和电话线测试,显示连接顺序和号码
的LAN电缆
6.多协议支持三十多个PTZ协议。如PELCO-P,PELCO-D,
三星
7.支持RS232 / RS485 / RS422,速率600〜115200bps可调
8.锂离子聚合物电池。该器件采用先进的电源控制和保护电路
9.同时在屏幕上显示数据和图像。
火车几乎不用了,容易使用
描述:
新型闭路电视测试仪是为网络摄像机,模拟摄像机和网络设备的现场安装和维护开发的,具有视频显示,云台控制,DC12v输出电源,音频测试,彩条发生器,RS 485数据搜索和电缆测试,这与以前的型号相同。新开发的功能包括POE电源测试,PING测试,IP地址扫描,电缆扫描,视频快照,数字万用表,光功率计,视频记录,图像放大,端口闪烁,LED灯等。新的测试仪也内置TDR电缆测试,专门为安全监控系统中的BNC电缆测试而设计。该功能可以准确测量BNC电缆和网线的断点和短路位置。设计具有易于操作和便携性的新测试仪使cctv技术人员或安装人员能够轻松安装和维护闭路电视系统,通过减少现场时间来提高工作效率。
规范:

模型
hvt cctv测试仪hvt-2613(第6代)
视频测试
信号模式 NTSC / PAL(自适应)
显示 3.5寸数字TFT-LCD,480(RGB)×320分辨率
LCD调节 亮度,对比度,饱和度可调
视频输入/输出 1通道BNC输入和1通道输出输出utput
视频输出模式 1.0 Vp-p
视频等级测试
水平测试 用IRE或mV测量的视频信号
云台控制器
通讯 支持RS232和RS485
云台协议 兼容30多种协议,如PELCO-D / P,三星,松下,林林,雅安等。
波特率 600,1200,2400,4800,9600,19200,57600,115200bps
视频信号生成
彩条发生器 输出一个通道PAL / NTSC彩条视频信号,用于测试显示器或视频电缆(红色,绿色,蓝色,白色和黑色)
UTP电缆测试
UTP电缆测试 测试UTP电缆连接状态并显示在屏幕上。阅读测试箱的编号。
DC12V 1A电源输出
DC12V电源输出 输出DC12V1A相机电源
电缆扫描
电缆扫描 通过音频信号搜索电缆
音频输入测试
音频输入测试 测试前端的拾音器和其他音频设备
RS485数据分析
数据监控 捕获并分析来自控制设备的命令数据
10 x放大图像
图像10x缩放 10倍缩放图像显示和视频输出
照片,录像,录像播放
照片 快照并将当前图像保存为JPG文件
视频记录 视频记录和存储文件
录制播放 查看SD卡中的存储文件
端口闪烁
端口闪烁 快速查找已连接的POE端口。
IP扫描,Link监视器,PING测试
IP扫描 找出所连接的IP摄像机或其他网络设备的IP地址。
链接监视器 检查IP地址是否被占用
PING测试 测试其他网络设备的IP摄像机或以太网端口是否正常工作,并检查IP地址
POE测试仪
POE测试仪 显示电源电压和电缆连接状态
光功率计
校准波长(nm) 850 /一千三百一十分之一千三/一千五百五十零分之一千四百九十零/ 1625nm的
功率范围(dBm) -70〜+ 10dBm的
灵敏度(NW) 0.001nW
连接器类型 FC / PC
数据保持 显示数据保持
相对测量 显示测量值
数字万用表
AC / DC电压 0-660V自动/手动量程,最小分辨率为0.1mV
AC / DC电流 660.0ua,6.600ma,66.00ma,660.0ma,10.00a
抵抗性 660.0Ω,6.600kΩ,66.00kΩ,660.0kΩ,6.600MΩ,66.00MΩ
电容 6.6nf〜66000uF,最小分辨率为1pf
二极管 0〜2V正向电压,最小分辨率为1mV
数据保持 保持测量光功率值
相对测量 显示第一个测试结果的差值
连续性测试 如果电阻低于50Ω,内置蜂鸣器会发出声音
测试速度 3次/秒
数据范围 -6600~+6600
TDR测试仪
TDR测试仪 断点和短路测量(BNC电缆,电话线)
功率
电源适配器 直流5v(1.5a)
电池 内置3.7V锂聚合物电池,3000mAh
充电 充电3-4小时后,工作时间为11小时
消费低 节能技术,电池图标实时显示
参数
操作设置 英文/中文等语言OSD菜单
自动关闭 5-60(分钟)
按键音 开关
一般
工作温度 -10ºC--- +50ºc-+50ºCrdm;C-+50ºC
工作湿度 30%-90%
尺寸/重量 194mm x 112mm x 48mm / 540g




Model NO. HVT-2613
Screen Size 3.5 Inch
Aspect ratio 3.5 Inch
Optimum Resolution 480*320
Response Time 3ms
Interface Type HDMI
Specification CE, FCC
HS Code 9031809090
Type TFT
Application Big-Screen Project, Indoor, Outdoor
Feature LED Backlight Display, Support TV Function
Widescreen Not Widescreen
3D Not 3D
Trademark EYEVISON
Origin Shenzhen, China

Cable Continuity Tester CCTV Camera Accessories , CCTV Camera Tester with Multimeter
Quick Detail:
1. Device Port flicker, easy to find the connected POE switch port by sending special signals, the connected POE port will flicker at special frequency.
2. Link monitor; check the setting IP address whether occupied
3. TDR break point and short - circuit measurement( BNC cable, network cable etc)
4. PTZ address scan, search up the ID of PTZ camera.
5. Network cable and Telephone cable testing, display the sequence of connection and the No
of the LAN cable
6. Multi-protocol. Supports more than thirty PTZ protocols. Such as PELCO-P, PELCO-D,
SAMSUNG
7. Support RS232/RS485/RS422, rate 600 ~ 115200bps adjustable
8. Lithium Ion Polymer Battery. The device employs advanced power control and protection circuit
9. Display the data and image in on the screen at the same time.
10. Easy for use that the train is almost unnecessary
Description:
The new CCTV tester is developed for the On-Site installation and maintenance of IP camera, analog camera and network device, with Video display, PTZ control, DC12v output power, Audio test, Color bar generator, RS 485 Data searching and Cable testing, which are the same to the previous models. The new developed functions include POE power supply testing, PING testing, IP address scan, Cable scan, Video snapshot, Digital multimeter, Optical power meter, Video record, Image magnification, Port flicker, LED lamp etc. The new tester also has built in TDR cable testing, which is specialized designed for BNC cable testing in the security monitoring system. This function can accurately measure BNC cable and network cable's break point and short-circuit location. The new tester designed with easy operation and portability makes it simple for a cctv technician or installer to install and maintain CCTV systems, improving work efficiency by reducing time in the field.
Specification:

Model
HVT CCTV TESTER HVT-2613 ( 6th generation)
Video Test
Signal mode NTSC/PAL (Auto adapt)
Display 3.5 inch digital TFT-LCD ,480(RGB)x 320 resolution
LCD adjustment Brightness, Contrast, Saturation adjustable
Video IN/OUT 1 channel BNC Input & 1 channel Outpututpututput
Video Output Mode 1.0 Vp-p
Video Level test
Level test Video signals measured in IRE or mV
PTZ controller
Communication Support RS232 and RS485
PTZ Protocol Compatible with more than 30 protocols such as PELCO-D/P, Samsung, Panasonic, Lilin, Yaan, etc.
Baud Rate 600,1200,2400,4800,9600,19200,57600,115200bps
Video Signal Generation
Color bar generator Output one channel PAL/NTSC color bar video signal for testing monitor or video cable.(red, green ,blue, white and black color )
UTP Cable Test
UTP cable test Test UTP cable connection status and display in the screen. Read the number of the test box.
DC12V 1A power output
DC12V power output Output DC12V1A power for camera
Cable Scan
Cable Scan Search the cable by the audio signal
Audio input test
Audio input test test the pickup and other audio equipments on the front-end
RS485 data analysis
Data Monitor Captures and analyzes the command data from controlling device
10 x zoom of image
Image 10x zoom 10x zoom image display and video out
Photograph, Video record, Record playback
Photograph snapshot and save the current image as JPG file
Video record Video record and storage the file
Record playback To view the storage file in the SD card
Port flicker
Port flicker Find the connected POE port quickly.
IP scan, Link monitor, PING test
IP scan Find out the connected IP camera or the other network equipment IP address quickly.
Link monitor Check the IP address whether is occupied
PING testing Test IP camera or Ethernet port of the other network equipment whether work normally, and check the IP address
POE tester
POE tester Display the power supply voltage and cable connection states
Optical power meter
Calibrated Wavelength(nm) 850/1300/1310/1490/1550/1625nm
Power range(dBm) -70~+10dBm
Sensitivity(nW) 0.001nW
Connector type FC/PC
Data hold Display data hold
Relative measurement Display the measurement value
Digital Multimeter
AC/DC Voltage 0-660V auto/manual range, the min resolution is 0.1mV
AC/DC current 660.0uA , 6.600mA, 66.00mA , 660.0mA, 10.00A
Resistance 660.0Ω, 6.600kΩ, 66.00kΩ, 660.0kΩ, 6.600MΩ, 66.00MΩ
Capacitance 6.6nf~66000uF, the min resolution is 1pf
Diode 0~2V forward voltage, the min resolution is 1mV
Data hold Hold the measurement optical power value
Relative measurement display the difference value of the first testing result
Continuity testing Built-in buzzer will sound, if resistance is lower than 50 Ω
Testing speed 3 times/ seconds
Data range -6600~+6600
TDR Tester
TDR Tester breakpoint and short circuit measurement(BNC cable, telephone cable)
POWER
Power Adapter DC 5V(1.5A)
Battery Built-in 3.7V Lithium polymer battery ,3000mAh
Rechargeable After charging 3-4 hour, working time lasts 11 hours
Low Consumption Energy saving technology, the battery icon real-time display
Parameter
Operation setting English/Chinese and other languages OSD menu
Auto off 5-60 (mins)
Key tone On/Off
General
Working Temperature -10ºC---+50ºC-+50ºCrdm;C-+50ºC
Working Humidity 30%-90%
Dimension/ Weight 194mm x 112mm x 48mm / 540g