光纤网络交换机千兆IEEE802.3AF 155M，网络交换机
介绍：
8端口标准POE交换机通过单个Cat-5电缆使用以太网供电（PoE）为无线接入点和IP摄像机提供电源和数据。 8个以太网端口可用于任何10/100 Mbps链路，并可提供行业标准的IEEE 802.3af电源。高级自动检测功能仅供802.3af供电设备使用，因此无需担心损坏专有PoE或非PoE设备。此外，当PoE设备断开连接时，它会中断电源。标准自动确定PoE要求，速度，双工和电缆类型，使用自动检测方便可靠。
特征：
8端口，poe，1端口10 / 100M光纤
完全ieee80.2af /标准编译器
支持每个港口的poe最高可达15.4w
自动检测电源设备（PD）
安全可靠的电源到端子装置
即插即用，无需配置uired
规范：

安装方便：
通过以太网的数据和电力从一个单元，poe开关应减少电缆，并消除在墙壁，天花板或任何不可达的地方专用电源插座的需要。导线同时承载数据和降低安装成本的功率，简化了安装工作，消除了对电工或延长线的需求。这是扩展您的家庭或办公室网络的绝佳选择。

Fiber Optic Network Switch Gigabit IEEE802.3AF 155M , Switches In Networking
Introduction:
The 8 ports Standard POE switch provides power and data to wireless access point and IP camera, using Power over Ethernet(PoE) over a single Cat-5 cable. The 8 Ethernet ports can be used for any 10/100 Mbps link and also can supply industry-standard IEEE 802.3af power. Advanced Auto detection gives power only to 802.3af powered devices, so no need to worry about damaging proprietary PoE or non-PoE equipment. In addition, it discontinues the power when PoE devices are disconnected. Easy and reliable, the standard automatically determines PoE requirements, speed, duplex, and cable type using Auto detection.
Features:
8 ports with poe,1 ports 10/100M fiber
fully ieee80.2af/at standard compilant
support poe poer up to 15.4w for each port
auto detect powered device(PD)
safe and reliable power to ech of poe end device
plug&play,no configuration requireduireduired
Specification:

Easy Cabling Installation:
With data and power over Ethernet from one unit, The poe switch shall reduce cables and eliminates the need for dedicated electrical outlets on the wall, ceiling or any unreachable place. A wire carries both data and power lowering the installation costs, simplifying the installation effort and eliminating the need for electricians or extension cords. It is a great selection for expanding your home or office network.