1~60kVA Power Frequency Online Uninterruptible Power System

1~60kVA Power Frequency Online Uninterruptible Power System

1〜60kVA电源频率在线不间断电源系统

333-5444 USD

加入意向
型号。 SNU-160
类型 线上
应用 电力
待机时间 标准机
输出容量 大型
效率 >95%
面板 液晶显示器
商标 SNAT
起源 广东佛山
单相
保护 密封维护免费
分类 照明/动力
待机UPS 正弦波输出UPS
SNAT
切换时间 0s
OEM / ODM 接受
规范 ISO9001
HS编码 8504402000


产品介绍

该系列电力在线智能UPS由SNAT公司设计,具有高稳定性和可靠性,旨在为全世界电网环境和网络系统提供电源可靠性要求

特征:
一,优良的品质可为用户数据中心和工业控制,医疗系统精密设备的负载提供安全可靠的综合保护
II。采用DSP,MCU和DDC实时处理全数字矢量控制技术,具有完美的保护功能和高可靠性
III。双转换,纯正弦波输出在线,无论在电源或电池模式下,都可以输出纯正弦波电源的低失真度,为用户的负载设备提供最佳的电源保证

Charactistics:
- 高可靠性设计
- 具有很强的保护装载能力
- 对环境的适应性强
- 高电池优化性能
- 全面可靠的保护
- 网络管理人性化

技术参数
1. 单机技术参数:
1KVA~20KVA 单独的技术参数
类型 1KVA 2KVA 3KVA 6KVA 10KVA 15KVA 20KVA
额定功率(KW) 0.8千瓦 1.6千瓦 2.4千瓦 4.8千瓦 8千瓦 12千瓦 16千瓦
输入电压 两个单相+接地线220V±25%usmn; 25%usmn;25%
电池电压 48VDC 96 / 192VDC 192 / 384vdc
噪声 ≤52dB(1m以内)1m) 1m) ≤60dB(1m以内)1m) 1m)
尺寸(宽*深*高mm) 256×618×626618×626es;626618×626 370×690×763690×763es;763690×763
重量(公斤) 30 40 45 60 105 130 160

2. Three阶段单出技术参数
10KVA~60KVA 三相单机技术参数
类型 10KVA 15KVA 20KVA 30KVA 40KVA 50KVA 60KVA
额定容量(KW) 8千瓦 12千瓦 16千瓦 24千瓦 32千瓦 40千瓦 48千瓦
输入电压 四相三线+接地线,380V±25%usmn; 25%usmn;25%
电池电压 384vdc
噪声 ≤60dB(1m以内)1m) 1m) ≤65dB(1m以内)1m) 1m)
尺寸(宽*深*高mm) 370×690×763690×763es;763690×763 650×700×160000×1600s;160000×1600
重量(公斤) 165 190 210 400 450 530 620

通用技术天平
通用技术天平
输入 频率 50Hz / 60Hz的±10%usmn; 10%usmn;10%
功率因数 ≥80%; 80%;80%
产量 电压 220V±1%lusmn; 1%lusmn;1%
电压调节 稳定±1%lusmn; 1%lusmn;1%,动态±2%lusmn; 2%lusmn;2%,(0-100%负载变化 <20ms20ms)
频率 稳定性
50Hz / 60Hz的±0.5%SMN; 0.5%smn;0.5%
频率反向率 <1Hz/sHz/s
谐波失真 线性负载 <3%( full loaded), Rectifier total harmonic<5%c<5%
过载能力 130%
波形 纯正弦波
效率 输入AC到输出AC >95%
切换时间 在电源与电池之间切换 0
在旁路模式下切换电源 < 4ms 4ms
电池 类型 密封酸免费维修
充电时间 完全放电后8小时充电至90%
保护功能 电池 自动切断功率较低;无保险丝开关保护
超载 3〜3秒后120〜150%切换到旁路模式,自动恢复
过温 内部温度 >85ºc85ºc;C85ºC 自动切换到旁路模式
输出短裙 自动切断功率较低;保险丝和无保险丝开关保护ction
UPS异常 自动切换到旁路模式,并通过电源供电
液晶显示器 输入/输出电压;频率;电池电压;输出负载
环境 温度 -10~50ºCordm;Çordm;C
相对湿度 20%〜93%无结露
高度 < 1000m

工作模式:
正常情况下
当市电供电正常时,滤波器通过输入滤波器进行杂波,然后发送到整流器进行整流调整,然后将直流电源发送到变频器变换成稳定的交流电源,通过静态开关到EMI输出滤波器进行进一步滤波,最后得到纯正且稳定的交流电源供给负载。 同时,电网通过另一个分支供电充电器进行充电后再充电。在整个工作过程中,电池不输出任何电源
2.电池操作
当电源输入故障时,电池通过隔离二极管对变频器供电,然后通过变频器转换为稳定的交流电,通过静态开关到EMI滤波器进行进一步滤波,最后在输出端也有负载稳定的电源。 在整个过程中,UPS输出完全不间断 电源为电池供电。

3.
自动旁路模式:
当UPS处于自动旁路模式的情况下, 过滤后, 输入电源不需要变频器,而是直接到静态开关,滤波后输出滤波。 在旁路模式下,电源也可以充电到电池。


保证:
质量保证1年;零件将在保修期内免费发货。
交货时间:
坚持合同

任何要求,欢迎联系 刘小姐: 点击贸易信使; 电话:+86 757 81816131;手机:+86 18039293535。,
您将在12小时内收到我们的答复
Model NO. SNU-160
Type On-line
Application Electricity Power
Standby Time Standard Machine
Output Capacity Large Type
Efficiency >95%
Panel LCD Display
Trademark SNAT
Origin Foshan Guangdong
Phase Single Phase
Protection Sealed Maintenance Free
Classification Lighting/Power
Standby UPS Sine Wave Output UPS
Brand Snat
Switch Time 0s
OEM/ODM Accept
Specification ISO9001
HS Code 8504402000


Products Introduction

This series power frequency online intelligent UPS is designed by SNAT company with high stability and reliability, aim to the whole world power grid environment and network system for power supply reliability requirements

Feature:
I. The excellent quality can provide safe and reliable comprehensive protection for the loads of the user data centers and industrial control, precision equipment of the medical system
II. Using DSP, MCU and DDC real-time processing of full digital vector control technology, with perfect protection function and high reliability
III. Double conversion, pure sine wave output online, no matter in the electric supply or battery mode, can output pure sine wave power supply of low distortion degree, provides the best of power supply guarantee for the loads equipment of the user

Charactistics:
--High reliability design
--With strong protection ability to load
--Strong adaptability to the environment
--With high battery optimize performance
--With comprehensive and reliable protection
--Network management humanization

Technology Parameter
1. Singly into single out technology parameter:
1KVA~20KVA Singly into single out technology parameter
Type 1KVA 2KVA 3KVA 6KVA 10KVA 15KVA 20KVA
Rated Power(KW) 0.8KW 1.6KW 2.4KW 4.8KW 8KW 12KW 16KW
Input Voltage Two single-phase + ground wire 220V±25%usmn;25%usmn;25%
Battery voltage 48VDC 96/192VDC 192/384VDC
Noise ≤52dB(within 1m) 1m) 1m) ≤60dB(within 1m) 1m) 1m)
Size(W*D*Hmm) 256×618×626618×626es;626618×626 370×690×763690×763es;763690×763
Weight(Kg) 30 40 45 60 105 130 160

2. Three phases single out technology parameter
10KVA~60KVA Three phases single out technology parameter
Type 10KVA 15KVA 20KVA 30KVA 40KVA 50KVA 60KVA
Rated Capacity(KW) 8KW 12KW 16KW 24KW 32KW 40KW 48KW
Input Voltage Four three-phases + ground wire,380V±25%usmn;25%usmn;25%
Battery Voltage 384VDC
Noise ≤60dB(within 1m) 1m) 1m) ≤65dB(within 1m) 1m) 1m)
Size(W*D*Hmm) 370×690×763690×763es;763690×763 650×700×160000×1600s;160000×1600
Weight(Kg) 165 190 210 400 450 530 620

General Technology Parapeter
General Technology Parapeter
Input Frequency 50Hz/60Hz±10%usmn;10%usmn;10%
Power factor ≥80%;80%;80%
Output Voltage 220V±1%lusmn;1%lusmn;1%
Voltage regulation stabilization±1%lusmn;1%lusmn;1%,dynamic±2%lusmn;2%lusmn;2%,(0-100% load change <20ms20ms)
Frequency stability
50Hz/60Hz±0.5%smn;0.5%smn;0.5%
Frequency reverse rate <1Hz/sHz/s
Harmonic distortion Linear loads <3%( full loaded), Rectifier total harmonic<5%c<5%
Overload capacity 130%
Waveform Pure sine wave
Efficiency Input AC to Output AC >95%
Switching time Switch between mains with battery 0
Switch between mains with bypass mode < 4ms 4ms
Battery Type Sealed acid for free maintenance
Charging time 8 hours charge to 90% after completely discharge
Protective function Battery Automaticly cut off with lower power; No fuse switch protection
Overload 120~150% switch to bypass mode after 3s and recover automaticly
Over temperature Internal temperature ﹥85ºC85ºC;C85ºC switch to bypass mode automaticly
Output short cirtuit Automaticly cut off with lower power; fuse & no fuse switch protectionctionction
UPS abnormal Switch to by bypass mode automaticly and power by mains supply
LCD display Input/Output voltage; Frequency; Battery voltage; Output load
Environment Temperature -10~50ºCordm;Cordm;C
Relative humidity 20%~93% No condensation
Altitude < 1000m

Working Mode:
1. Under normal
When Mains supply is normal, filter to clutter by inputting filter and then sent to the rectifier do rectifier adjustments, and then sent dc power to inverter transform into stable ac power, through static switch to the EMI output filter for further filter, finally get the pure and stable ac power supply to the loads. At the same time, the grid through another branch supply charger after transformation charging for rechargeable batteries.In the process of the whole work, battery do not output any power
2.Battery Operation
When mains input fault, battery power to inverter by isolating diode, then be converted to stable AC by inverter, through static switch to the EMI filter for further filtering, last on the output side also have the pure and stable power supply to loads. UPS output completely uninterruptible during the whole process from mains power to battery power.

3.
Automaticly bypass mode:
When UPS is under the situation for automaticly bypass mode, after filter, Input mains convert no need by inverter, but directly to the static switch, the output by filter after filtering. In the state of bypass mode, mains power also can charge to battery.


Warranty:
Quality warranty for 1 year; parts will be shipped for free during warranty period.
Delivery time:
Stick to contract.

Any requirements, welcome to contact with Sabrina Liu: Click Trade messenger; Tel: +86 757 81816131; Mobile: +86 18039293535.,
You will get our reply in 12 hours