滤泡单位提取FUE头发移植机的说明
微电机手机
1.可以调节中间银白色部分，转向上旋转，头夹口打开，此时将附件放入间隙，然后旋转右侧，间隙闭合，夹紧，然后可供电上班。
2.将手柄转到上部中间的银色部分时，头夹开口，此时不能打开电源。
3.手柄部分只能调节中间银色部分，黑色和灰色部分无法调节。
主要操作说明：
所有部件都是一对一接口
2.如果使用脚踏开关，必须步脚可以工作。
3.主控电源的电源出厂前已经调整好了，红板已经显示出220V的电压，请不要更改未经许可。如果你的国家电压是110伏，你可以改变它，直到红板显示110v。
灭菌方法：
配件可以进行高温高压灭菌，对于其他部分，使用熏蒸或用酒精消毒，然后一次性包装灭菌袋密封。禁止浸泡
标准清单：
电机：1pc
电手柄：1pc
植入拳针：10支
镊子：2支（直头和肘头）
5.植入笔：3支（直径：0.8mm，1.0mm，1.2mm）
6.硅胶块：1pc
7.进口刀柄和英国刀片：1套
脚踏开关
9.包装盒
指令DVD

The instructions of Follicular Unit Extraction FUE Hair Transplantation Machine
Micromotor handpiece
1. Can adjust intermediate silvery white part, turn to the upper rotating, head clip mouth open, at this time, put accessory into the the gap, and then spin to the right, the gap closed, will clamp tight, then can supply power to work.
2. When turning the handle to the upper middle silver parts, head clip mouth open, at this time can not turn on the power.
3. Handle part only adjustable intermediate silver part, black and gray part can not be adjusted.
Main operating instructions:
1. All parts are one-on-one interface
2. If use foot switch, must step foot that can work.
3. The power supply of main control button, before they leave the factory has been adjusted, red plate have shown that 220 v voltage, please don't change without permission. If your country voltage is 110 v, you can change it till red plate show 110v.
Sterilization method:
Accessories can be high temperature and high pressure sterilization, for other part, use fumigation or with alcohol disinfection, then pack in one-time sterilization bag seal. Ban soak.
Stardard list:
1. Motor: 1pc
2. Electric handle: 1pc
3. Implantation punches: 10pcs
4. Tweezer: 2pcs (straight head and elbow head)
5. Implantation pen: 3pcs (dia: 0.8mm,1.0mm,1.2mm)
6. Silicon block for hair: 1pc
7. Imported implantation knife handle and UK blade: 1 set
8. Foot switch
9. Packing case
10. Instruction DVD