Ha-3200A Ce批准麻醉机
| 型号。 | HA-3200A |
| 类 | 麻醉机 |
| 组 | 成人及Childrenildrenldren |
| 资源 | 医用氧和一氧化二氮 |
| 医疗器械监管类型 | 类型3 |
| 额定电压 | LED显示屏 |
| 保证 | 12个月 |
| 模式 | 气动和电控 |
| 商标 | Healicom |
| 规范 | ce,iso |
| HS编码 | 9018909090 |
| 类型 | 麻醉机 |
| 证明 | ce,iso13485 |
| 液晶显示器 | 带LCD显示屏 |
| 麻醉 | 关闭;半封闭;半开放式 |
| 医疗器械注册/记录号 | Gsyjxzz20093540256 |
| 适当 | 成人与儿童Child |
| 工作模式 | 关闭;半封闭;半开放式 |
| 证书 | ce iso |
| 运输包装 | 纸板箱 |
| 起源 | 中国江苏 |

| 技术规格 | |
| 物理规格 | |
| 屏幕 | LED显示屏 |
| 适当 | 成人与儿童节Child |
| 模式 | 气动和电控系统 |
| 工作模式 | 关闭;半封闭;半开放式 |
| 电路 | 呼吸电路综合标准 |
| 管 | 2管流量计:O2:0.1〜10L / Min,N2O:0.1〜10L / min |
| 手推车 | 配有4个防静电橡胶脚轮;其中两个可锁定,用于制动,并且具有脚踏操纵制动器的易操作性 |
| 抽屉单元 | 一个抽屉完全可以抽出 |
| 技术规格: | |
| 燃气要求 | 医用氧气和一氧化二氮压力范围从 o2:0.32〜0.6mpa; no2:0.32 mpa至0.6 mpa。 |
| 安全阀门 | <12.5 kPa kPa |
| 呼吸频率 | 4〜40bpm |
| 流量计 | o2:0.1〜10l / min,n2o:0.1〜10l / min |
| 混合气N2O / O2中的氧浓度 | > 21% |
| 氧气冲洗: | 25〜75L / min |
| 压力测试装置的最大误差 | 不超过±(全量程阅读的4%+实际读数的8%)读数)reading) |
| 通风方式 | a / c,ippv,sippv,手册 |
| I / E比率 | 1:1.5; 1:2.0;1:2.5; 1:3 |
| 潮量 | 0〜1500毫升 |
| 受控通气和辅助换气时间 | 6s |
| 最大安全压力 | ≤12.5 kPa kPa kPa |
| 压力极限范围 | 0〜6.0 kPa |
| 气道压力报警:视听和黄色和红色指示 | 下限:0.2kPa〜5.0kPa;上限:0.3〜6.0 kPa |
| ±0.2 kPa; 0.2 kPa;0.2 kPa | |
| 潮气量报警:视听和黄色和红色指示 | 上限报警:50〜2000ml,下限报警:0〜1800ml |
| 电源报警 | AC / DC电源发生故障后立即发出报警 闹钟时间:保持> 120s120s |
| 运行条件 | |
| 环境温度 | 10〜40℃ |
| 相对湿度 | 不高于80% |
| 气压 | 860 hPa〜1060 hPa |
| 电力需求: | 100-120 Vac,50 / 60Hz; |
| 空气源要求 | 医用氧气和笑气,额定压力范围为0.3〜0.5MPa。 |
| 注意:用于麻醉机的交流电源必须接地良好。 | |
| 注意:所使用的麻醉机必须配备符合ISO 9918:1993的二氧化碳监测仪,符合ISO 7767:1997的氧气监测仪,符合医疗电气设备51.101.4.2的呼气量监测仪第二部分:特殊要求用于麻醉系统的安全和基本性能。 | |
| 组态: | |
| 喷雾器 | 恩氟烷/异氟烷(选项:氟烷) |
| 存储 | |
| 环境温度 | -15oC〜+ 50oC |
| 相对湿度 | 不高于95% |
| 气压 | 86 kPa〜106 kPa。 |
| 应储存在没有腐蚀性气体和通风良好的房间内 | |
| 包 | |
| 包装盒 | 符合GB / T 15464的要求 |
| 在包装盒和产品之间,提供适当厚度的柔软材料,以防止运输过程中松动和相互摩擦 | |
| 防潮防雨,确保产品免受自然损害。 | |
| 安全防范报警Alarm | |
| 氧气报警器 | 当管道或气缸的氧气供应低于0.2MPa时,报警 |
| 通风量报警 | 下限:0〜12L / min; 上限:18L / min |
| 电力报警 | 交流和直流电源故障时,保持阿拉姆时间:> 120s120s |
| 标准配置 | |
| 数量 | 名称 |
| 1套 | 主机 |
| 1套 | 内置呼吸机 |
| 1套 | 2管流量计 |
| 1套 | 喷雾器 |
| 1套 | 病人回路 |
| 1套 | 怒吼 |
| 1套 | 钠石灰罐 |
| 1套 | 隔膜电子传感器 |
| 1张照片 | 氧气减压器 |
| 2图片 | 皮包(蓝色) |
| 4图片 | 螺纹管 |
| 2图片 | 面具 |
| 1套 | 工具与机器 |
| 1套 | 用户手册(英文版) |
| 可选的 | 病人监护仪 |



| Model NO. | HA-3200A |
| Kind | Anesthesia Machine |
| Group | Adults&Childrenildrenldren |
| Source | Medical Oxygen and Nitrous Oxide |
| Medical Device Regulatory Type | Type 3 |
| Nominal-Voltage | LED Display Screen |
| Warranty | 12months |
| Mode | Pneumatically Powered and Electrically Controlled |
| Trademark | Healicom |
| Specification | CE, ISO |
| HS Code | 9018909090 |
| Type | Anaesthesia Machine |
| Certification | CE, ISO13485 |
| LCD Display | With LCD Display |
| Anesthesia | Closed; Semi-Closed; Semi-Open |
| Medical Devices Reg./Record No. | Gsyjxzz20093540256 |
| Suitable | Adult & Child ChildChild |
| Working Mode | Closed; Semi-Closed; Semi-Open |
| Certificate | CE ISO |
| Transport Package | Carton |
| Origin | Jiangsu, China |

| TECHNIQUES SPECIFICATIONS | |
| Physical specifications | |
| Screen | LED Display Screen |
| Suitable | Adult & ChildChildChild |
| Mode | pneumatically powered and electrically controlled system |
| Working Mode | Closed; Semi-Closed; Semi-Open |
| Circuit | Breathing circuit integrated standards |
| Tube | 2 Tubes Flowmeters: O2:0.1~10L/Min, N2O:0.1~10L/Min |
| Trolley | Fitted with 4 nos anti-static rubber castors; two of which are lockable for braking and easy maneuverability with foot operated brake provisions |
| Drawer unit | ONE drawer totally extractable |
| Technical Specifications: | |
| Gas requirement | Medical oxygen and nitrous oxide with a pressure ranging from O2: 0.32~0.6MPa ; NO2: 0.32 MPa to 0.6 MPa. |
| Safety valve | <12.5 kPa kPa |
| Respiratory Rate | 4~40bpm |
| Flow meter | O2:0.1~10L/Min, N2O:0.1~10L/Min |
| Oxygen concentration in the mixed gas N2O/O2 | > 21% |
| Oxygen Flush: | 25~75 L/min |
| Maximum error of the pressure testing device | not exceed ± (4% of the full scale reading + 8% of the actual reading)reading)reading) |
| modes of ventilation | A/C,IPPV, SIPPV, MANUAL |
| I/E Ratio | 1:1.5; 1:2.0;1:2.5; 1:3 |
| Tidal Volume | 0~1500ML |
| Controlled ventilation and assisted ventilation switching time | 6s |
| Maximum safety pressure | ≤ 12.5 kPa kPa kPa |
| Pressure limit range | 0 ~ 6.0 kPa |
| Airway pressure alarm: Audible and visual and with yellow and red color indicating | Lower: 0.2kPa~5.0kPa; Upper: 0.3~6.0 kPa |
| ±0.2 kPa;0.2 kPa;0.2 kPa | |
| Tidal volume alarm: Audible and visual and with yellow and red color indicating | upper alarm: 50 to 2000ml,lower alarm: 0~1800ml |
| Power Supply Alarm | Ac/dc power supply are after failing to send out alarm immediately Alarm Time: keep ﹥120s120s |
| Operating conditions | |
| Ambient temperature | 10 ~ 40oC |
| Relative humidity | no higher than 80 % |
| Atmospheric pressure | 860 hPa ~ 1060 hPa |
| Power requirement: | 100-120 Vac, 50/60 Hz; |
| Air source requirement | Medical oxygen and laughing gas with a rated pressure ranging from 0.3 to 0.5MPa. |
| Attention: the AC power supply used for the anesthesia machine must be well grounded. | |
| Attention: the anesthesia machine used must be equipped with a carbon dioxide monitor complying with ISO 9918:1993, an oxygen monitor complying with ISO 7767:1997 and an expiratory gas volume monitor complying with 51.101.4.2 of Medical Electrical Equipment Part II: Special Requirements for Safety and Basic Performance of Anesthesia System. | |
| Configuration: | |
| Vaporizer | Enflurane/ Isoflurane(Option: Halothane) |
| Storage | |
| Ambient temperature | -15oC ~ +50oC |
| Relative humidity | no higher than 95 % |
| Atmospheric pressure | 86 kPa ~ 106 kPa. |
| It should be stored in a room without corrosive gas and well ventilated | |
| Package | |
| packaging box | comply with the requirement of GB/T 15464 |
| Between the packaging box and product, soft material with appropriate thickness provided to prevent loosening and mutual friction during transportation | |
| Moisture protection and rain protection to ensure that product is protected from natural damage. | |
| Safety & AlarmAlarmAlarm | |
| Oxygen Alarm | It alarms when the oxygen supply from pipe or cylinders lower than 0.2MPa |
| Ventilation Volume Alarm | Lower: 0~12L/Min; Up: 18L/ Min |
| Power Alarm | It Alrmas while AC and DC supply failure ; Keep alraming time: ﹥120s120s |
| STANDARD CONFIGURATIONS | |
| QTY | NAME |
| 1 set | Main unit |
| 1 set | Built in ventilator |
| 1 set | 2-tube flow meter |
| 1 set | vaporizer |
| 1 set | Patient circuit |
| 1 set | bellow |
| 1 set | Na lime tank |
| 1 set | Diaphragm electronic sensor |
| 1 pic | Oxygen pressure reducer |
| 2 pics | A leather bag ( Blue) |
| 4 pics | Threaded pipe |
| 2 pics | mask |
| 1 set | Tools with the machine |
| 1 set | User Manual (English Version) |
| Optional | Patient Monitor |


