型号B-6111
高频操作：
1.每次使用前后消毒配件。
2.打开主电源。
3.打开电源。
4.根据客户的皮肤类型调整强度f。
5.完成使用时，将强度转为最小（点击声）
交换电极
当交换玻璃电极时，请注意电极上的胶水很热。拉出电极时请慢慢扭曲，以保持胶水到位。如果拉出电极，请保持温和，以防玻璃破裂。
高频执行方法
杀菌效果（直接法）高频直接法
1.使用“蘑菇”玻璃棒。玻璃棒。
2.限制皮脂分泌。
杀菌，抗菌效果好。
4.干燥和愈合感染。
随着客户放松（没有首饰），操作员打开机器。
操作人员将一只手放在客户的脸上，并将电极施加于脸部。
7.电极直接在小圆圈的表面上旋转，不要抬起电极。
8.操作人员将手放在客户端并移除电极。
高频表面组织起火方法的刺激
1.使用“蘑菇”玻璃棒。玻璃棒。
2.渗透到皮下组织（脂肪面）。
3.产生增加血液组织液流动的热量。
4，改善营养和消除皮肤。
5，改善肌肤质地，保持肌肤水分平衡。
6，操作员设置与“直接法”程序相同，但电极稍微离开皮肤，产生火花
身体高频间接法的放松效应
1，在组织内产生温暖，产生镇静作用。
2，增加放松和缓解张力。
3，不影响肌肉。
4，客户双手握住“直”玻璃电极（无珠宝）。
5，操作人员一手放在客户面前。
6，为了找出正确的强度，操作人员慢慢打开机器的强度，同时轻轻按摩脸部，询问客户是否感觉到皮肤的温暖或刺痛感。
7，当客户感觉到温暖或刺痛的感觉时，对于该客户来说，强度是最佳的。
8，用双手轻轻按摩脸部。请勿将手指从面部抬起。
9，按摩5分钟，然后休息2分钟;然后再开始
10，用一只手关闭机器。
注意事项：
客户必须在治疗前脱掉所有珠宝。
2.第一次使用高频或长时间没有使用时，可能看起来不起作用。但是，这是正常的反应。只要把高频打开一段时间，它会再次工作。
3.在高频下使用闪光效果时，请使用湿棉片遮盖眼睛。只需触摸需要消毒的地方，最长时间为10秒。客户会感到刺痛。

Model No B-6111
High Frequency Operations:
1. Sterilize accessories before and after each usage.
2. Switch Main Power on.
3. Switch power on.
4. Adjust intensity f according to client's skin type.
5. Turn intensity to minimum(click sound)when finish using or
Exchanging electrodes.
When exchange glass electrodes, please be careful that the glue on the electrode is hot. Please twist slowly when pulling out the electrode in order to keep the glue in place. If pull the electrode out, please be gentle in case the glass will break.
Methods of Performing High Frequency
Germicidal Effect (Direct Method Only) Direct Method of High Frequency
1. Use the 'mushroom' glass rod.; glass rod.
2. Limits sebaceous secretion.
3. Germicidal, anti-bacterial effect.
4. Drying and healing infection.
5. With client relaxed (no jewelry on) the operator turns on machine.
6. Operator places one hand on the client's face and applies the electrode to the face.
7. The electrode is rotated directly on the face in small circles, Do not lift electrode.
8. The operator places hand on client's and removes electrode.
Stimulation of Surface Tissue Sparking Method of High Frequency
1. Use the 'mushroom' glass rod. glass rod.
2. Penetrates to subcutaneous tissue (adipose face).
3. Generates heat that increases flow of blood tissue fluids.
4, Improves nutrition and elimination of skin.
5, Improves skin texture, oil and moisture balance to skin.
6, Operator sets up the same as in Direct Method procedure but electrode is lifted slightly away from the skin to create a sparking
Relaxation effect on Body Indirect Method of High Frequency
1, Generates warmth within tissues, produces sedative effect.
2, Increases relaxation and relief from tension.
3, Does not affect muscles.
4, Client holds 'straight' glass electrode in both hands (no jewelry on).ewelry on).
5, Operator places one hand on clients face.
6, To find out the right intensity, operator slowly turns on and up the intensity of the machine at the same time lightly massaging the face and asking the client if they feel a warm or prickly sensation to the skin.
7, When the client feels the warm or tingling sensation, the intensity is at its best for that client.
8, Massage the face with both hands now with light strokes. Do not lift the fingers from the face.
9, Massage for five minutes and then rest for two minutes; Then start again.
10, Turn off machine with one hand.
Cautions:
1. Client has to take off all jewelry before treatment.
2. When use high frequency for the first time or it has not been used for a long while, it may seem not working. However, it is a normal reaction. Just turn the high frequency on for a while, and it will be working again.
3. When using sparkling effect on high frequency, use wet cotton slices to cover eyes. Only touch where it needs to be sterilized, maximum time of 10 seconds. Client will feel tingling.