Medical Electric Operating Table for Best Price (MSLMO08)
医疗电动手术台（MSLMO08）
多用途工作台（型号MSLMO08）
该台紧凑地设计并坚固地构造，并且可以通过油泵液压地升高或降低。它们适用于头部，颈部，胸部，腹部，会阴和四肢的外科手术，以及用于妇科，产科，泌尿和鼻 - 鼻 - 喉科手术。可以快速，安全地调整各种位置。
控制装置，手轮和曲柄手柄安装在工作台的头端。表的所有位置完全从头端控制。
型号3008B的机箱内外盖为不锈钢。其结构和技术参数相同。
规格：
桌面尺寸：
总长... 2040±40（mm）
宽度... 480±20（mm）
部分尺寸：
头枕... 280×320（mm）
后部... 500×480（mm）
肾桥... 84×470（mm）
座椅部分... 370×480（mm）
腿部... 500×480（mm）
脚踏... 200×535（mm）
地板上：
最大。高度... 1040±50（mm）
最小。高度... 800±50（mm）
运动范围：
最大。翻转Trendelenburg ...≥50°
最大。 Trendelenburg ...≥30°
最大。侧向倾斜...≥20°
章节调整：
头部从水平升起...≥45°
头部从水平位置降下...≥90°
背面从水平方向升起...≥80°
背面从水平方向降低...≥8°
肾桥高程...≥120mm
腿从水平方向降低...≥90°
脚踏板可以保持水平或垂直于腿部。
注意事项：
1，头枕调整采用严格的牙锁。如果头枕的位置需要调整，则必须先将齿锁杆分离并调整到合适的位置，松开，否则容易损坏。
2，润滑油应添加到每个活动部分，以便床可以很容易地操作，并延长他们的生活。在床的每一侧和桌子下面的架子上的附件的轨道上涂抹凡士林，从而防止其生锈。
3，在使用前，应检查所有附件是否牢固锁定，以防止其在使用时脱落或滑落。
4，由于床有很多零件，保持所有的配件良好的秩序。
5，每次操作后，清洗床上的污垢，保持床和配件清洁，延长他们的生活。
6，地面必须保持干燥。当地板被洗涤和擦洗，请尽量不要让水溅入板或旋转的轮子，从而防止生锈。
7，必须每年定期修理和保持清洁。
8，在临床使用中，手术台的侧倾角大于8度（标准等于或大于20度），用户应考虑患者从桌面跌落的可能性，并选择身体框架和身体带等，以确保使用安全。
该装置应在室内储存，相对湿度小于80％，无腐蚀性空气，通风良好。无侧倾。
它可以定期运输，没有碰撞，振荡，雨或阳光直射。
该台紧凑地设计并坚固地构造，并且可以通过油泵液压地升高或降低。它们适用于头部，颈部，胸部，腹部，会阴和四肢的外科手术，以及用于妇科，产科，泌尿和鼻 - 鼻 - 喉科手术。可以快速，安全地调整各种位置。
控制装置，手轮和曲柄手柄安装在工作台的头端。表的所有位置完全从头端控制。
型号3008B的机箱内外盖为不锈钢。其结构和技术参数相同。
规格：
桌面尺寸：
总长... 2040±40（mm）
宽度... 480±20（mm）
部分尺寸：
头枕... 280×320（mm）
后部... 500×480（mm）
肾桥... 84×470（mm）
座椅部分... 370×480（mm）
腿部... 500×480（mm）
脚踏... 200×535（mm）
地板上：
最大。高度... 1040±50（mm）
最小。高度... 800±50（mm）
运动范围：
最大。翻转Trendelenburg ...≥50°
最大。 Trendelenburg ...≥30°
最大。侧向倾斜...≥20°
章节调整：
头部从水平升起...≥45°
头部从水平位置降下...≥90°
背面从水平方向升起...≥80°
背面从水平方向降低...≥8°
肾桥高程...≥120mm
腿从水平方向降低...≥90°
脚踏板可以保持水平或垂直于腿部。
注意事项：
1，头枕调整采用严格的牙锁。如果头枕的位置需要调整，则必须先将齿锁杆分离并调整到合适的位置，松开，否则容易损坏。
2，润滑油应添加到每个活动部分，以便床可以很容易地操作，并延长他们的生活。在床的每一侧和桌子下面的架子上的附件的轨道上涂抹凡士林，从而防止其生锈。
3，在使用前，应检查所有附件是否牢固锁定，以防止其在使用时脱落或滑落。
4，由于床有很多零件，保持所有的配件良好的秩序。
5，每次操作后，清洗床上的污垢，保持床和配件清洁，延长他们的生活。
6，地面必须保持干燥。当地板被洗涤和擦洗，请尽量不要让水溅入板或旋转的轮子，从而防止生锈。
7，必须每年定期修理和保持清洁。
8，在临床使用中，手术台的侧倾角大于8度（标准等于或大于20度），用户应考虑患者从桌面跌落的可能性，并选择身体框架和身体带等，以确保使用安全。
该装置应在室内储存，相对湿度小于80％，无腐蚀性空气，通风良好。无侧倾。
它可以定期运输，没有碰撞，振荡，雨或阳光直射。
Multi-Purpose Operating Table (Model MSLMO08)
This table are compactly designed and sturdily constructed, and may be raised or lowered hydraulically by means of an oil pump. They are suitable for surgical procedures of the head, neck, thorax, abdomen, perineum and extremities as well as for gynaecological, obstetrical, urological and oto-rhino-laryngological operations. Various positions can be quickly and safely adjusted.
The controlling devices, hand wheels and crank handles are mounted at the head-end of the table. All positions of the table are controlled entirely from the head-end.
Chassis inside & outside cover of model 3008B are stainless steel. The structures and technical parameters are the same.
1. Specifications:
Dimensions of Table Top:
Overall length...2040± 40(mm)
Width...480± 20(mm)
Dimensions of Sections:
Head Rest...280× 320(mm)
Back section...500× 480(mm)
Kidney Bridge...84× 470(mm)
Seat Section...370× 480(mm)
Leg Section...500× 480(mm)
Foot Rest...200× 535(mm)
Table Top from Floor:
Max. Height...1040± 50(mm)
Min. Height...800± 50(mm)
Range of Movements:
Max. Reversed Trendelenburg...≥ 50°
Max. Trendelenburg...≥ 30°
Max. Lateral Tilt...≥ 20°
Adjustments of Sections:
Head Rest-raised from the horizontal...≥ 45°
Head Rest-lowered from the horizontal...≥ 90°
Back Section-raised from the horizontal...≥ 80°
Back Section-lowered from the horizontal...≥ 8°
Kidney Bridge Elevation...≥ 120mm
Leg Section-lowered from the horizontal...≥ 90°
Foot Rest-can be kept horizontally or perpendicularly to the Leg Section.
Cautions:
1, The Head-rest adjustment is adopted by a strict teeth lock. If the position of the head-rest needs adjusting, the teeth lock pole must be first separated and adjusted to suitable position, the got loose, otherwise it is easily damaged.
2, Lubricating oil should be added to every active part, so that the bed can be operated easily and prolong their life. Smear Vaseline over the tracks of the accessories on each side of the bed and the racks under the table, thus preventing it from being rusty.
3, Before putting into use, all attachments should be checked to see if they are locked securely so as to prevent them from loosing or sliding off while used.
4, As the bed has many parts, keep all the accessories in good order.
5, After operating every time, clean the dirt on the bed, keep the bed and accessories clean and prolong their life.
6, The ground must be kept dry. While the floor is washed and scrubed, please try not to make water spill into the plate or on the rotated wheels, thus preventing it from being rusty.
7, It must be repaired and kept clean regularly once a year.
8, In the clinical use, the lateral lean angle of the operating table is bigger than 8 degrees (the standard is equal or bigger than 20 degrees), the user should think the possibility that the patient falls from the table top, and selects a body frame and body belt and so on to ensure the use safety.
This device in package should be stored indoor with a relative humidity less than 80%, no erosive air and good ventilation is required. No side-sloping.
It can be shipped in regular transportation without crash, oscillation, rain or direct sunlight.
This table are compactly designed and sturdily constructed, and may be raised or lowered hydraulically by means of an oil pump. They are suitable for surgical procedures of the head, neck, thorax, abdomen, perineum and extremities as well as for gynaecological, obstetrical, urological and oto-rhino-laryngological operations. Various positions can be quickly and safely adjusted.
The controlling devices, hand wheels and crank handles are mounted at the head-end of the table. All positions of the table are controlled entirely from the head-end.
Chassis inside & outside cover of model 3008B are stainless steel. The structures and technical parameters are the same.
1. Specifications:
Dimensions of Table Top:
Overall length...2040± 40(mm)
Width...480± 20(mm)
Dimensions of Sections:
Head Rest...280× 320(mm)
Back section...500× 480(mm)
Kidney Bridge...84× 470(mm)
Seat Section...370× 480(mm)
Leg Section...500× 480(mm)
Foot Rest...200× 535(mm)
Table Top from Floor:
Max. Height...1040± 50(mm)
Min. Height...800± 50(mm)
Range of Movements:
Max. Reversed Trendelenburg...≥ 50°
Max. Trendelenburg...≥ 30°
Max. Lateral Tilt...≥ 20°
Adjustments of Sections:
Head Rest-raised from the horizontal...≥ 45°
Head Rest-lowered from the horizontal...≥ 90°
Back Section-raised from the horizontal...≥ 80°
Back Section-lowered from the horizontal...≥ 8°
Kidney Bridge Elevation...≥ 120mm
Leg Section-lowered from the horizontal...≥ 90°
Foot Rest-can be kept horizontally or perpendicularly to the Leg Section.
Cautions:
1, The Head-rest adjustment is adopted by a strict teeth lock. If the position of the head-rest needs adjusting, the teeth lock pole must be first separated and adjusted to suitable position, the got loose, otherwise it is easily damaged.
2, Lubricating oil should be added to every active part, so that the bed can be operated easily and prolong their life. Smear Vaseline over the tracks of the accessories on each side of the bed and the racks under the table, thus preventing it from being rusty.
3, Before putting into use, all attachments should be checked to see if they are locked securely so as to prevent them from loosing or sliding off while used.
4, As the bed has many parts, keep all the accessories in good order.
5, After operating every time, clean the dirt on the bed, keep the bed and accessories clean and prolong their life.
6, The ground must be kept dry. While the floor is washed and scrubed, please try not to make water spill into the plate or on the rotated wheels, thus preventing it from being rusty.
7, It must be repaired and kept clean regularly once a year.
8, In the clinical use, the lateral lean angle of the operating table is bigger than 8 degrees (the standard is equal or bigger than 20 degrees), the user should think the possibility that the patient falls from the table top, and selects a body frame and body belt and so on to ensure the use safety.
This device in package should be stored indoor with a relative humidity less than 80%, no erosive air and good ventilation is required. No side-sloping.
It can be shipped in regular transportation without crash, oscillation, rain or direct sunlight.
