MY-I017B MAYA医疗电动分娩床价格优惠
电动分娩床（MY-I017B型）
1，概述：
a）用法：这张床是为妇女分娩和妇科手术而设计的。
b）说明：床面流线型符合患者身体姿势，电动调节满足整体倾斜度，整体倾斜度调整产床表高度，特别适用于妇科，泌尿外科，镜检查诊断。
2，规格：
桌面尺寸：
总长度.................................... 1200mm
宽度..........................................550毫米
桌面从地板：
最大高度....................................1200毫米
Min.Height .......................................480毫米
运动范围：
逆转德国伦敦..............................≥15°; 15°deg;;15°
头低脚高....................................≥20°; 20°deg;;20°
补充：AC220±10％，50Hz10％，50Hz10%,50Hz
设备安全排序：I B
3，分娩床组成：
分娩床由机构和电气控制系统组成。
该机构由床体，腿架，污染池，辅助设备等组成，电器控制系统由内控制器，传动系统，手柄控制器等组成。
4，操作说明：
1）电动调整满足整体倾斜度。整体倾斜调整产床表高度。它有一个移动的控制按钮容器。控制按钮均为点按钮，当必要按钮被冲下时，对应的电机将工作，当按钮不起动时，所有动作停止。
2）床面，头枕由聚氨酯垫制成，易于脱模和消毒。
3）床盆下面有一个隐藏的污垢盆，可以方便地拉出或推入，以方便处理脏水和碎屑。
4）底座的移动和稳定。通过顺时针方向松开底座的把手，桌子可以移动。相反，它可以稳定下来。
5）腿架可以前后移动，围绕旋转，高度调节，锁定方便。
6）本公司将根据用户需要提供电路图。
5，附件：
1）应在每个活动部位加入润滑油，使床易于操作，延长使用寿命。在床的每一侧的配件的轨迹上和在桌子下方的机架上涂抹凡士林，从而防止其生锈。
2）投入使用前，应检查所有附件是否牢固锁定，以防止使用时松动或滑落。
3）保持床和配件的清洁，延长寿命。
4）地面必须保持干燥。当地板被洗涤和擦洗时，请尽量不要让水溅入板或转动的轮子上，从而防止其生锈。
5）将床放在干燥的地方，避免电气控制装置潮湿而损坏。
6）保持按钮容器干燥并清洁以避免电流泄漏。保持在正确的
使用后的地方
7）产品可以电动操作2个动作。这些动作必须分开操作。注意：本产品由单相交流（220V，50Hz），三插座供电。使用插头额定值为2A。请仔细检查插座以确保可靠的接地;停止执行时切断电源。遇到麻烦时，请通知公司/机构对工程师进行检修，不要自行检修。不要按电缆，避免在使用过程中损坏电缆或隔离。
8）必须每年修理一次，定期清洁一次。
9）电动分娩床的更换部件正常使用期限，已确认报废（无法使用），应按分类（可回收和不可回收）进行处理。
10）电动分娩床的使用寿命为7年。如果在过期中使用，可能导致部分机械部件的磨损和腐蚀，对机械强度有负面影响。患者也许受苦所以操作台应在常规维护和安全使用期间使用。
11）防静电地面必须使用电动分拣床。
警告：电动分娩床与高频手术设备配合使用，操作人员和患者有可能被烧伤。
7，清洁消毒灭菌
1，禁止用水冲洗手术台。
2，用软布，海绵，湿布或洗涤剂清洁手术台。不用硬刷，钢丝刷，去污粉，油漆，乙醚，香蕉水，酸碱溶液到任何表面。
3，床垫必须用酒精，乙醚，紫外线消毒等进行消毒（放弃高温消毒）。
8，环境条件
运输和库存环境条件
a）环境温度：-40ºC〜+55ºC+55ºC。dm;C.+55ºC.
b）相对湿度：≤80％.80％。80%.
c）大气压：50kPa〜106kPa。
移动环境条件
a）环境温度：5ºC〜40ºC〜40ºC。dm;C.~40ºC.
b）相对湿度：≤70％.70％。70%.
c）大气压力：70.0kPa〜106.0kPa。
d）电源电压：AC220V，50Hz±1Hzsmn; 1Hzsmn;1 Hz
该包装中的装置应在室内存放，相对湿度小于80％，不需要侵蚀性空气和良好的通风。没有侧倾。
它可以定期运输，没有碰撞，振荡，下雨或阳光直射。

MY-I017B MAYA Medical Electric Parturition Bed with good price
Electric Parturition Bed(Model MY-I017B)
1,General Description:
a) Usage:This bed is designed for women's parturition and gynecological operation.
b) Description: The bed surface is streamline and conforms to the patient body posture.The dynamoelectric adjustment satisfy whole inclination.The obstertric table altitude is adjusted by the whole inclination.It can be especically used for gynecology,urology surgery,mirror check and diagnosis.
2,Specifications:
Dimensions of Table Top:
Overall length....................................1200mm
Width..........................................550mm
Table Top from floor:
Max.Height....................................1200mm
Min.Height.......................................480mm
Range of movements:
Reversed Trendelenburg..............................≥15°;15°deg;;15°
Trendelenburg....................................≥20°;20°deg;;20°
Supple: AC220±10%,50Hz10%,50Hz10%,50Hz
Device safety sort:I B
3,Parturition bed composition:
The parturition bed is composed of the mechanism and the electrical control system.
The mechanism is composed of the bed body, the leg frame, the contaminative basin, the auxiliary equipment and so on, the electric appliance control system is composed of inside controller, the transmission system, handle controller and so on.
4,Operation Instruction:
1)The dynamoelectric adjustment satisfy whole inclination.The obstertric table altitude is adjusted by the whole inclination. It has a moving controlling push button container attached. The controlling push button are all dot buttons, when the necessary button is rushed, the corresponding motor will work, when the button is not puessde, all movements stop.
2)The bed surface,the head pillow is made of polyurethane cushion which is easy to unlade and sterilize.
3)There is a hidden dirt basin below bed pots, which can be easily pulled out or pushed in to facilitate treating dirty water and debris.
4) The moving and stabilization of the base. By loosening Handle of the base clockwise, the table can move. On the contrary, it can be stabilized.
5)Leg rack can be moved front and back, around rotation, height adjustment, Lock convenience.
6) The Company will be able to provide circuit draws in accordance with users' needs.
5,Accessories:
1) Lubricating oil should be added to every active part, so that the bed can be operated easily and prolong their life. Smear Vaseline over the tracks of the accessories on each side of the bed and the racks under the table, thus preventing it from being rusty.
2) Before putting into use, all attachments should be checked to see if they are locked securely so as to prevent them from loosing or sliding off while used.
3) keep the bed and accessories clean and prolong their life.
4) The ground must be kept dry. While the floor is washed and scrubed, please try not to make water spill into the plate or on the rotated wheels, thus preventing it from being rusty.
5 )Put the bed in dry place to avoid the electric controlling devices being wet and being damaged.
6) Keep the button container dry and clean to avoid current leakage. Keep it in the proper
place after being used.
7) The product can electrically operate 2 movements. These movements must be operated separately.Attention: the product is supplied by single-phase alternating current (220V, 50Hz), tri-socket .Fuse plug rating is 2A .Please carefully inspect socket to insure reliable earth; shut off power while stop perform. When trouble happen please inform company /agency to assign engineer overhaul, don't overhaul by yourself. Don't press cables avoiding to damage cable or isolation during usage.
8)It must be repaired and kept clean regularly once a year.
9) The replacement parts during Electric parturition bed normal using period, has been confirmed scrapped (unable to use), should be handled according to the classification (recyclable and non-recovery).
10) The service life for Electric parturition bed is seven years. If it is used in expired period, it maybe led to wearing and corrosion of some mechanical parts, and had a negative influence upon the mechanical intensity. The patients maybe suffered. So the operating table should be used in the regular maintenance and during safety using period.
11) Electric parturition bed must be used on the antistatic ground.
Warning: electric parturition bed coupled with high-frequency surgical equipment for use, it is possible for the operator and patients to be burned.
7,Cleaning, disinfection and sterilization
1,Washing the operating table with water is prohibited.
2,Clean operating table with a soft cloth, sponge, wet cloth or detergent. Not use a hard brush, steel wire brush, decontamination powder, paint, ether, bananas water, acid-base solution to any surface.
3,Mattress must be disinfection with alcohol, ether, ultraviolet disinfection and so on (abandoning high-temperature disinfection).
8,Environmental condition
Transportation and stockpile environmental conditions
a)Environmental temperature:-40ºC~+55ºC.+55ºC.dm;C.+55ºC.
b)Relative humidity:≤80%.80%.80%.
c)Atmospheric pressure:50kPa~106kPa.
Moving environmental conditions
a)Environmental temperature:5ºC~40ºC.~40ºC.dm;C.~40ºC.
b)Relative humidity:≤70%.70%.70%.
c)Atmospheric pressure: 70.0kPa~106.0kPa.
d)Supply voltage: AC220V,50Hz±1 Hzsmn;1 Hzsmn;1 Hz
This device in package should be stored indoor with a relative humidity less than 80%, no erosive air and good ventilation is required. No side-sloping.
It can be shipped in regular transportation without crash, oscillation, rain or direct sunlight.