Hospital Anesthesia System/Anesthesia Ventilator Machine
医院麻醉系统/麻醉呼吸机
ICU和手术室的专业分类和解决方案
医院手术室设备麻醉呼吸机
屏幕：LED显示屏
适合：成人与儿童
模式：气动和电控系统
工作模式：关闭;半封闭;半开放
电路：呼吸电路集成标准
管：2管流量计：O2：0.1〜10L / Min，N2O：0.1〜10L / Min
推车：4个防静电橡胶脚轮;其中两个是可锁定的制动和容易机动性与脚踏制动设置
帅福得：NO2自动切割，缺氧
抽屉单元：两个抽屉完全可抽出
医院手术室设备麻醉呼吸机
屏幕：LED显示屏
适合：成人与儿童
模式：气动和电控系统
工作模式：关闭;半封闭;半开放
电路：呼吸电路集成标准
管：2管流量计：O2：0.1〜10L / Min，N2O：0.1〜10L / Min
推车：4个防静电橡胶脚轮;其中两个是可锁定的制动和容易机动性与脚踏制动设置
帅福得：NO2自动切割，缺氧
抽屉单元：两个抽屉完全可抽出
| 物理规格 | |
| 屏幕： | LED显示屏 |
| 适当 | 成人与儿童 |
| 模式： | 气动和电控系统 |
| 工作模式： | 关闭;半封闭;半开放 |
| 电路 | 呼吸回路综合标准 |
| 管： | 2管流量计：O2：0.1〜10L / Min，N2O：0.1〜10L / Min |
| 手推车： | 配有4个防静电橡胶脚轮; 其中两个可锁定的制动和容易 使用脚踏式制动装置的机动性 |
| 安全 | NO2自动切割，缺氧 |
| 抽屉单元 | 两个抽屉完全可抽出 |
| 技术规格： | |
| 气体要求： | 医用氧气和一氧化二氮具有压力范围 从O2：0.32〜0.6MPa; NO2：0.32MPa〜0.6MPa。 |
| 安全阀门 | <12.5kPa |
| 呼吸频率 | 4〜40bpm |
| 流量计 | o2：0.1〜10l / min，n2o：0.1〜10l / min |
| 混合气体中的氧气浓度N2O / O2 | > 21％ |
| 氧气冲洗： | 25〜75L / min |
| 压力测试装置的最大误差 | 不超过±（满刻度读数的4％+实际读数的8％） |
| 通气模式 | a / c，ippv，sippv，手册 |
| I / E比率： | 1:1.5; 1:2.0;1:2.5; 1:3 |
| 潮量 | 0〜1500ml |
| 控制通风和辅助 通风切换时间 | 6s |
| 最大安全压力： | ≤12.5kPa |
| 压力极限范围： | 0〜6.0kPa |
| 气道压力报警：声音 和视觉和黄色和红色指示 | 低：0.2kPa〜5.0kPa;上限：0.3〜6.0 kPa |
| ±0.2kPa | |
| 潮气量报警：声音和视觉和 与黄色和红色颜色表示 | 上限报警：50〜2000ml，下限报警：0〜1800ml |
| 电源报警 | 交流/直流电源发生故障后立即发出报警 报警时间：保持> 120s |
| 运行条件 | |
| 环境温度： | 10〜40℃ |
| 相对湿度： | 不高于80％ |
| 气压： | 860 hPa〜1060 hPa |
| 电力需求： | 100-120 Vac，50 / 60Hz; |
| 空气源要求： | 医疗氧气和笑气与 额定压力为0.3〜0.5MPa。 |
| 注意：用于麻醉机的交流电源必须良好接地。 | |
| 注意：使用的麻醉机必须配备 符合ISO 9918：1993的二氧化碳监测器， 符合ISO 7767：1997的氧气监测器 符合51.101.4.2的呼气量监测器 医疗电气设备第二部分：特殊要求 麻醉系统的安全和基本性能。 | |
| 组态： | |
| 蒸发器 | 安氟醚/异氟烷（选项：氟烷） |
| 存储 | |
| 环境温度： | -15oC〜+ 50oC |
| 相对湿度： | 不高于95％ |
| 气压： | 86 kPa〜106 kPa。 |
| 应储存在无腐蚀性气体，通风良好的房间内 | |
| 包 | |
| 包装盒 | 符合GB / T 15464的要求 |
| 在包装盒和产品之间，软材料 其具有适当的厚度以防止松动 和运输过程中的相互摩擦 | |
| 防潮防雨保护 该产品受到保护免受自然损害。 | |
| 功率 | |
| 电源报警 | 听觉和视觉 |
| 电池电量 | 典型30分钟+，最多180分钟 |
| 铅酸蓄电池 | |
| 输出电压DC12V | |
| 它应该以不超过12小时的间隔充电。 | |
Professional assortment and solutions for ICU and operation room
Hospital operation room device anesthesia ventilator machine
Screen: LED Display Screen
Suitable: Adult & Child
Mode: pneumatically powered and electrically controlled system
Working Mode: Closed; Semi-Closed; Semi-Open
Circuit: Breathing circuit integrated standards
Tube: 2 Tubes Flowmeters: O2:0.1~10L/Min, N2O:0.1~10L/Min
Trolley: Fitted with 4 nos anti-static rubber castors; two of which are lockable for braking and easy maneuverability with foot operated brake provisions
Saft: NO2 Automaticlly Cutting while oxygen deficiency
Drawer unit: Two drawer totally extractable
Hospital operation room device anesthesia ventilator machine
Screen: LED Display Screen
Suitable: Adult & Child
Mode: pneumatically powered and electrically controlled system
Working Mode: Closed; Semi-Closed; Semi-Open
Circuit: Breathing circuit integrated standards
Tube: 2 Tubes Flowmeters: O2:0.1~10L/Min, N2O:0.1~10L/Min
Trolley: Fitted with 4 nos anti-static rubber castors; two of which are lockable for braking and easy maneuverability with foot operated brake provisions
Saft: NO2 Automaticlly Cutting while oxygen deficiency
Drawer unit: Two drawer totally extractable
| Physical specifications | |
| Screen: | LED Display Screen |
| Suitable | Adult & Child |
| Mode: | pneumatically powered and electrically controlled system |
| Working Mode: | Closed; Semi-Closed; Semi-Open |
| Circuit | Breathing circuit integrated standards |
| Tube: | 2 Tubes Flowmeters: O2:0.1~10L/Min, N2O:0.1~10L/Min |
| Trolley: | Fitted with 4 nos anti-static rubber castors; two of which are lockable for braking and easy maneuverability with foot operated brake provisions |
| Safty | NO2 Automaticlly Cutting while oxygen deficiency |
| Drawer unit | Two drawer totally extractable |
| Technical Specifications: | |
| Gas requirement: | Medical oxygen and nitrous oxide with a pressure ranging from O2: 0.32~0.6MPa ; NO2: 0.32 MPa to 0.6 MPa. |
| safety valve | ﹤12.5 kPa |
| Respiratory Rate | 4~40bpm |
| Flow meter | O2:0.1~10L/Min, N2O:0.1~10L/Min |
| oxygen concentration in the mixed gas N2O/O2 | ﹥ 21% |
| Oxygen Flush: | 25~75 L/min |
| Maximum error of the pressure testing device | not exceed ± (4% of the full scale reading + 8% of the actual reading) |
| modes of ventilation | A/C,IPPV, SIPPV, MANUAL |
| I/E Ratio: | 1:1.5; 1:2.0;1:2.5; 1:3 |
| Tidal Volume | 0~1500ML |
| Controlled ventilation and assisted ventilation switching time | 6s |
| Maximum safety pressure: | ≤ 12.5 kPa |
| Pressure limit range: | 0 ~ 6.0 kPa |
| Airway pressure alarm: Audible and visual and with yellow and red color indicating | Lower: 0.2kPa~5.0kPa; Upper: 0.3~6.0 kPa |
| ±0.2 kPa | |
| Tidal volume alarm: Audible and visual and with yellow and red color indicating | upper alarm: 50 to 2000ml,lower alarm: 0~1800ml |
| Power Supply Alarm | Ac/dc power supply are after failing to send out alarm immediately Alarm Time: keep ﹥120s |
| Operating conditions | |
| Ambient temperature: | 10 ~ 40oC |
| Relative humidity: | no higher than 80 % |
| Atmospheric pressure: | 860 hPa ~ 1060 hPa |
| Power requirement: | 100-120 Vac, 50/60 Hz; |
| Air source requirement: | Medical oxygen and laughing gas with a rated pressure ranging from 0.3 to 0.5MPa. |
| Attention: the AC power supply used for the anesthesia machine must be well grounded. | |
| Attention: the anesthesia machine used must be equipped with a carbon dioxide monitor complying with ISO 9918:1993, an oxygen monitor complying with ISO 7767:1997 and an expiratory gas volume monitor complying with 51.101.4.2 of Medical Electrical Equipment Part II: Special Requirements for Safety and Basic Performance of Anesthesia System. | |
| Configuration: | |
| Vaporizer | Enflurane/ Isoflurane(Option: Halothane) |
| Storage | |
| Ambient temperature: | -15oC ~ +50oC |
| Relative humidity: | no higher than 95 % |
| Atmospheric pressure: | 86 kPa ~ 106 kPa. |
| It should be stored in a room without corrosive gas and well ventilated | |
| Package | |
| packaging box | comply with the requirement of GB/T 15464 |
| Between the packaging box and product, soft material with appropriate thickness provided to prevent loosening and mutual friction during transportation | |
| Moisture protection and rain protection to ensure that product is protected from natural damage. | |
| Power | |
| Power supply alarm | Audible and visual |
| Battery Power | Typical 30 mins +, upto180mins |
| lead-acid battery with a rated | |
| output voltage of DC 12V | |
| It should be charged at an interval no longer than 12h. | |
