描述：

这是一套明确和远程无线监控系统。

接收器的外形美观，这两个摄像头的通道可以通过手工或自动更改。

相机有逆光补偿，自动白平衡等功能。

它有24个红外灯，当照度低于2〜4勒克斯，红外线自动开启，可以达到最佳的夜视效果。 该监督画面清晰，颜色鲜艳。 它适合于居住区，办公，超市，饭店，仓库，医院等的监视

一般规格：

• 传输频率：ISM 2.414至2.468 GHz的
• 传输功率：10mW / CE; 为2mW / FCC
• 通畅有效范围：5-15M
• 调制方式：FM
• 工作温度：-10至+50（摄氏度）/ +14至+122（华氏度）
• 储存温度：-20〜+ 60（℃）/ -4至+140（华氏度）
• 工作湿度：（= 85％RH

摄像头规格：

• 电视制式：PAL / NTSC
• 有效性像素：PAL：628（H）×582（V）
• NTSC：510（H）×492（V）
• 图像设备：中星微0702愿景CMOS
• 水平清晰度：380电视线
• 查看的视场角：45 *（F = 6毫米）
• 最低照度：1勒克斯
• 夜视距离为15m
• 带宽：25M
• 同步系统：内
• 扫描频率（H）：PAL：15.625KHz
• NTSC：15.734KHz
• 扫描频率（V）：PAL：50Hz的
• NTSC：60
• 红外灯：24颗LED灯红外
• 背光补偿：自动
• 电子快门：1/50（1/60）至1/100000秒
• 白平衡：自动
• S / N比：）48分贝
• 伽玛校正：）0.45
• 工作温度：-10至+50 / +14至+122摄氏度/华氏度
• 传输频率：ISM 2400至2483MHz
• 电源：DC + 12V
  
  

接收器规格：

• 接收频率：ISM 2400至2483MHz
• 中频：为480MHz
• 稳频：+ / - 为100KHz
• 解调方式：FM
• 天线：50欧姆SMA
• 接收灵敏度：（= -85dBm
• 视频输出：平1Vp-P @ 75欧姆，S / N）38dM
• 音频输出：3VP-P @ 600欧姆
• 工作温度：-10至+50 / +14至+122摄氏度/华氏度
• 工作湿度：85％RH
• 电源：DC + 12V

产品特点：

• （2.4GHz的）无线红外夜视摄像机。
• 红外夜视CCD无线摄像机15米夜视范围。
• 4通道接收器，2个摄像头的工作。
• 380电视线水平清晰度。
• 无阻挡5-15M的传输距离。
• PAL和NTSC制式。
• 内置麦克风摄像头使音频监视。

操作：

• 把相机在需要监控的地方。
• 插入电源适配器，电源适配器在接收机的电源输入插孔直流输出插头。
• 用AV线连接的音频和视频输入的电视机或监视器插头一个通道。
• 按关/遥控器上的按键，或按接收器的频道键，打开接收机的电源适配器。 开场后，接收器将默认通道1。
• 按频道键（标号1，2，3和4）的遥控器，使接收器的对应于所述接收器的发送器的频率的频率。
• 可以看到视频和收听通过电视或显示器的声音，调整摄像头的位置，瞄准监控对象，然后可以进行有效的监控。
• 按遥控器上的ON / OFF键，或按接收3秒可关闭接收机的电源频道按钮。

存在的问题及解决方案：

• 该频道显示窗口的指示灯不亮。 检查电源适配器的插座是否工作好不好，并确保电源开关打开。
• 该接收机无法接收图像或图像，接收到的闪烁。
• 请检查是否无线摄像机已通过电源已经推出。
• 无论是无线摄像头和接收器之间的距离过远或是否有无线摄像头和接收器之间的电磁屏蔽屏障（如：钢结构建筑将大大阻碍传输信号）。
• 在接受的范围，不要让两个无线相机在同一时间同一频率的工作，否则会造成干扰。
• 当在同一时间不同频率工作的发送摄像机，所述摄像机之间的距离应保持约或超过2米，否则接收将受到干扰。
• 如果存在具有相同的频率和车载收音机周围工作的高功率发送信号，它们将引起。

项目包括：

• 1个2.4GHz的4路远程无线AV接收器
• 1个天线用于接收器
• 2×2.4GHz的中星微0702展望24 LED红外日夜安全CCTV无线CMOS彩色影音摄像机
• 1个DC12V适配器接收器
• 2×DC12V适配器摄像头
• 1个遥控器

Description:

This is a set of clear and remote Wireless supervision system.

The appearance of the Receiver is beautiful and the Channels of the two Cameras can be changed by hand or automatically.

The Camera has the function of backlight compensation, automatic white balance and so on.

It has 24 IR LED, when the illumination is below 2 to 4 Lux, the infrared will open automatically and can reach the best night vision effect. The supervised picture is clear and the color is bright. It is suitable for the surveillance of residence area, office, supermarket, hotel, warehouse, hospital, etc.

General Specification:

• Transmission Frequency: ISM 2.414 to 2.468 GHz
• Transmission Power: 10mW/ CE; 2mW/ FCC
• Unobstructed Effective Range: 5-15m
• Modulation Mode: FM
• Operating Temperature: -10 to +50 (Degree C) / +14 to +122 (Degree F)
• Storage Temperature: -20 to +60 (Degree C) / -4 to +140 (Degree F)
• Operating Humidity: (=85%RH

Camera Specification:

• TV System: PAL/ NTSC
• Validity Pixel: PAL: 628 (H) x 582 (V)
• NTSC: 510 (H) x 492 (V)
• Image Device: Vimicro 0702 Vision CMOS
• Horizontal Definition: 380 TV Lines
• Angular Field of View: 45 * (f=6mm)
• Minimum Illumination: 1 Lux
• Night Vision Range: 15m
• Band Width: 25M
• Synchronization System: Internal
• Scanning Frequency (H) : PAL: 15.625KHz
• NTSC: 15.734KHz
• Scanning Frequency (V) : PAL: 50Hz
• NTSC: 60Hz
• IR LEDs: 24pcs LEDs Infrared
• Backlight Compensation: Auto
• Electronic Shutter: 1/50 (1/60) to 1/100000 Sec
• White Balance: Auto
• S/ N Ratio: ) 48db
• Gamma Correction: ) 0.45
• Operation Temperature: -10 to +50 / +14 to +122 degree C / degree F
• Transmission Frequency: ISM 2400 to 2483MHz
• Power Supply: DC +12V
  
  

Receiver Specification:

• Receiving Frequency: ISM 2400 to 2483MHz
• intermediate Frequency: 480MHz
• Frequency Stabilization: +/ - 100KHz
• Demodulation Mode: FM
• Antenna: 50 ohm SMA
• Receiving Sensitivity: (=-85dBm
• Video Output: 1Vp-p @ 75ohm, S/ N) 38dM
• Audio Output: 3Vp-p @ 600ohm
• Operation Temperature: -10 to +50 / +14 to +122 degree C / degree F
• Operation Humidity: 85%RH
• Power Supply: DC +12V

Features:

• (2.4GHz) Wireless Infrared night vision Camera.
• Infrared night vision CCD Wireless Camera with 15m night vision range.
• 4 Channel Receiver work with 2 Cameras.
• 380 TV Line Horizontal Definition.
• 5-15m transmission distance without block.
• PAL and NTSC system.
• Built-in Microphone in Camera enables Audio Monitoring.

Operation:

• Put the Camera in the place where need to monitor.
• Insert power Adapter, the DC Output Plug of power Adapter in the power Input jack of the Receiver.
• Use the AV Cable to connect one Channel of Audio and Video Input plugs of the TV set or Monitor.
• Press the off/ on key of the Remote Control, or press the Channel key of the Receiver and open the power Adapter of the Receiver. The Receiver will acquiesce the Channel 1 after opening.
• Press the Channel key (marked No. 1, 2, 3 and 4) of the remote control and make the Frequency of the Receiver corresponding to the transmitter Frequency of the Receiver.
• Can see the Video and listen to the voice through the television or monitor, adjust the place of the Camera, aiming at the monitoring object then can make the valid monitor.
• Press the ON/ OFF key of the remote control, or press the Channel button on the Receiver for 3 seconds to turn off the power of the Receiver.

The Problems And The Solutions:

• The indicator of the Channel display window is not lighting. Check whether the socket of the power Adapter works well or not, and make sure the power switch is turning on.
• The Receiver cannot receive picture or the picture-received flashes.
• Please check whether the Wireless Camera have already put through the power.
• Whether the distance between Wireless Camera and Receiver is too far or whether there is Electromagnetic shielding Barrier between Wireless Camera and Receiver (eg: Building of steel structure will make much hindrance to transmitting signal) .
• In the Range of Receiving, Don't make two Wireless Cameras with the same Frequency work at the same time, otherwise they will cause interfering.
• When the transmitting Cameras of different Frequency work at the same time, the distance between the Cameras should be kept about or over 2 meters, otherwise receiving will be interfered.
• If there are high-power transmission signals with the same Frequency and Car-mounted Radio working around, they will cause.

Item Includes:

• 1 x 2.4GHz 4Channel Remote Wireless AV Receiver
• 1 x Antenna for Receiver
• 2 x 2.4GHz Vimicro 0702 Vision 24 LED IR Day&Night Security cctv Wireless CMOS Color AV Camera
• 1 x DC12V Adapter for Receiver
• 2 x DC12V Adapter for Camera
• 1 x Remote Controller