2-wired Conventional Heat Detector for Fire Alarm System

2-wired Conventional Heat Detector for Fire Alarm System

2线火灾报警系统常规热探测器

3 USD

加入意向
兼容所有传统火灾报警控制面板
双LED:双LED闪烁待机,提供360°可见度
高精度电子热敏电阻:设计用于快速,准确地感测温度
无极性输入:防止接线错误的可能性

一般说明
该器件是智能传感器,利用先进的热敏电阻传感电路实现快速响应
这些传感器设计为提供具有50英尺间隔能力的开放区域保护
该器件是具有135°F固定温度报警的上升温度传感器
该器件是利用现有技术的双热敏电阻感测电路的固定温度报警热检测器的上升速率
这些探测器设计为提供具有50英尺间隔能力的开放区域保护,并且仅与兼容的控制面板一起使用
每个检测器上的两个LED发光,以提供检测器指示的360°可视性

特点和优点
*兼容所有常规火灾报警控制面板
*无极性线输入
*工作电压范围宽
*高精度电子热敏电阻
*内置微处理器智能软件
*两个LED闪烁待机,提供360°可见度
*防虫筛查
*带防拆锁的扭转安装底座
*可以连接远程指示灯

技术规格
直径:103mm
高度(包括安装基座):55mm
重量:155g
工作温度范围:-10°C至50°C
工作湿度范围:10%至93%相对湿度,无冷凝
锁定报警:由瞬时电源中断复位

电气额定值
系统电压(额定):24V DC(9V-28V DC)
待机电流:40μA@ 24V DC
报警电流:30mA @ 24V DC
固定温度额定值:57°C(135°F)
上升速率检测:响应速度大于15°F / min

Compatible with all conventional fire alarm control panel
Dual-LED: two-LED blink standby, provide 360° visibility
High precision electronic thermistor: engineered to sense temperature quick and accurate
Unpolarized wire input: to prevent the likelihood of wiring errors

General description
The device is intelligent sensors that utilize a state-of-the-art thermistor sensing circuit for fast response
These sensors are designed to provide open area protection with 50 foot spacing capability
The device is a rate-of-rise temperature sensor with 135°F fixed temperature alarm
The device is a rate-of-rise with fixed temperature alarm thermal detector utilizing a state-of-the-art dual thermistor sensing circuit
These detectors are designed to provide open area protection with 50-foot spacing capability, and are to be used with compatible control panels only
Two LEDs on each detector light to provide 360° visibility of the detector indication

Features and benefits
* Compatible with all the conventional fire alarm control panel
* Unpolarized wire input
* Wide range of operating voltages
* High precision electronic thermistor
* Built in microprocessor intelligent software
* Two LEDs blink standby, provide 360° visibility
* Insect-resistant Screening
* Twist-on mounting base with tamper lock
* Remote Indicator LED can be connected

Technical specifications
Diameter: 103mm
Height (including mounting base): 55mm
Weight: 155g
Operating temperature range: -10°C to 50°C
Operating humidity range: 10% to 93% relative humidity, non-condensing
Latching alarm: reset by momentary power interruption

Electrical ratings
System voltage (nominal): 24V DC (9V-28V DC)
Standby current: 40μA @ 24V DC
Alarm current: 30mA @ 24V DC
Fixed temperature rating: 57°C (135°F)
Rate of rise detection: responds to greater than 15°F/min