被动无钥门禁（PKE）

接近车，它会被自动解锁。 离开车程2.5米，它会被自动锁定。 如果其中一个门未关好，它会提醒司机的喇叭发声和转向灯闪烁。

按下按钮启动汽车

坐上去，踩刹车，并按下按钮，车子就会启动。 踩刹车，并再次推发动机将被停止的按钮。

远程发动机启动

按下遥控器上的LIGHT'button启动汽车。 通常情况下，它是用来使空调器驱动之前工作。

智能报警与防盗

锁定/解锁时，系统武器/自动撤防。 在布防状态，如果汽车被震惊或其中一个门强行打开，该系统会通过汽车喇叭报警和转向灯。 在同一时间，该系统将切断供油的车，以防止它窃取。

Windows可以自动关闭AfterLocking

有些车辆直接支持该功能; 有的需要安装一个自动关窗器。

关窗器： 电装置可驱动所述窗马达，通过检测同步信号以关闭窗户。 它独立工作; 不需要与我们的产品连接。

使用遥控器来找到你的车

按LOCK'button使车冠冕堂皇的光闪烁; 这可以帮助你快速找到你的车。

使用遥控器来打开汽车后备箱（needmotor驾驶干线）

按下后备箱按钮一会儿，系统将打开行李箱。

使用遥控器暂停PKE功能

按LOCK'and LIGHT键的同时暂停PKE部分，自动功能将bedisabled。 按这两个按钮再次，PKE将被激活。

自动暂停PKE

如果车子一直独自为24小时以上时，系统会自动停止寻找智能钥匙，以减少电力消耗。

锁定在第一次制动（可选）

车辆起动后，系统将锁定车门。 当汽车电源关闭时，系统将自动解锁车门。

由于很多车都有这样的功能已经，这个功能可以通过交换机上的主机的侧面取消。

技术指标

主机工作电压：DC 9.0V-18.0V
主机待机电流：（=30毫安@ 12V

LF检测距离：2米

智能钥匙工作电压：DC 2.0V〜4.0V DC

智能钥匙待机电流：（= 4uA的@ 3V

工作温度：-40〜+ 85摄氏度

遥控距离为30μm

Passive Keyless Entry (PKE)

Approach the car, it will be unlocked automatically. Leave the car away 2.5 meters, it will be locked automatically. If one of the doors was not closed well, it will remind the driver by the horn sounding and turn light flashing.

Push the button to start the car

Get on, step on the brake and push the button, the car will be started. Step on the brake and push the button again the engine will be stopped.

Remote Engine Start

Press the LIGHT'button on the remote to start the car. Normally, it is used to make the air conditioner working before driving.

Smart Alarm &Immobilizer

The system arms/ disarms automatically when locking/ unlocking. On arming status, if the car was shocked or one of the doors was opened forcedly, the system will alarm through the car horn and turn light. At the same time, the system will cut off the oil supply of the car to prevent it from stealing.

Windows Can Be Closed Automatically AfterLocking

Some vehicles support this function directly; some need to be installed a Window Closer.

Window Closer: an electrical device which can drive the window motors to close windows by detecting LOCKING signal. It works independently; don't need to connect with our product.

Use the remote to find your car

Press the LOCK'button to make the car sounding and light flashing; this can help you find your car fast.

Use the remote to open car trunk (needmotor-driving trunk)

Press the TRUNK button for a while the system will open the trunk.

Use the remote to suspend PKE function

Press the LOCK'and LIGHT button together to suspend PKE section, automatic functions will bedisabled. Press that two buttons again, PKE will be activated.

Suspending PKE automatically

If the car has been left alone for more than 24 hours, the system will stop finding smart key automatically to decrease electricity consumption.

Locking on First Braking (selectable)

After the car is started, the system will lock car doors. When the car power is turned off, the system will unlock car doors automatically.

As many cars have this kind of function already, this function can be cancelled by the switch on the side of the main unit.

Specifications

Main Unit Working Voltage: DC 9.0V-18.0V
Main Unit Standby Current: (=30mA@12V

LF Detecting Distance: 2m

Smart Key Working Voltage: DC 2.0V~DC 4.0V

Smart Key Standby Current: (=4uA@3V

Working Temperature: -40-+85 Centigrade

Remote Control Distance: 30m