Receiver/Transmitter Kit for Garage Door, with 2CH 12A/14V DC, 7A/120V AC and 433Mhz Load Current
用于车库门的接收器/发射器套件，带2CH 12A / 14V直流，7A / 120V交流和433Mhz负载电流
议价
加入意向- 用于车库门滑动门门
- 继电器最大负载电流：12A / 14V DC或7A / 120V AC
- 编程：
- 按P1：
- 在单稳态模式下编程R1的时间
- 在单稳态模式下编程R2的次数
- 在双稳态模式下编程R1的次数
- 在双稳态模式下编程R2的次数
- 按住您想要获取的无线遥控器的键，直到LED闪烁
- 擦除：
- 擦除单个代码：
- 按P2约2秒钟（松开键）
- LED将亮起，按遥控器上您要删除的键
- 清除所有获取的代码：
- 按P2键直到LED亮起（约8秒）
- 擦除单个代码：
- 按P1：
- 备注：
- 红色：电源
- 黄色：NA（关闭）
- 黑色：接地线
- 蓝色：CM（常见）
- 绿色：天线
- 灰色：NF（开放）
- 安装（控制开关）：
- 将CM和NF分别连接到开关的两个引脚或有线墙控制
- Used for garage door sliding door gate
- Biggest load current on relay: 12A/14V DC or 7A/120V AC
- Programming:
- Press the P1:
- Time to program R1 in monostable mode
- Times to program R2 in monostable mode
- Times to program R1 in bistable mode
- Times to program R2 in bistable mode
- Hold down the key of the radio remote control that you wouldlike to acquire until the LED blinks
- Erasing:
- Erasing single code:
- Press P2 for about two seconds (release the key)
- LED will light up, press the key on the radio remote controlthat you want to delete
- Erasing all codes acquired:
- Press P2 until the LED turns on (about 8 seconds)
- Erasing single code:
- Press the P1:
- Remarks:
- Red: power
- Yellow: NA (closed)
- Black: earth wire
- Blue: CM (common)
- Green: antenna
- Gray: NF (open)
- Installs (control switch):
- Link CM and NF separately to the two pins of the switch or thewired wall control
