负载共享模式LSM672N
负载共享模式(KSL672N)
1)说明 - 的负载共享模块的功能是两个或更多个发电机组之间成比例地共享负载,同时在系统频率保持恒定。 作为附件的电子管理系统,该KSL 672措施的真正威力电流,throught并行电缆互连,连续控制调速器系统。
2)性能
加载SharingAdjustable内套之间+ / -2%
性能。 同步和下垂并联和电源控制
反向电源监视器。 0.5-20%可调带2第二逆时间常数
正向功率MonitorONtrip点从20-100%可调
OFFtrip点从0-80%可调
与2秒倒数时间常数常开触点
3)功率输出
信号。 0至7.5伏直流电代表0-100%的负载
所有性能规格基于5安培从电流互感器(CT)二级工具在满负载功率因数的统一
4)电源输入
AC输入信号。 。 208或416伏的标称线对线和5安培互感器用最少6.25额定VA。 内部0.25欧姆的负载电阻
线对线下方voltagesper表
HZ LOW范围上限范围
50 140-250 VAC 260-420 VAC
60 170-260 VAC 340-500 VAC
400 170-260 VAC 340-500 VAC
DC电源。 。 18-36 VDC(瞬态和反向电压保护)
DC功耗。 70毫安连续
5)重量:2.41千克
6)相关产品:
KSL672
KSS6714












Load Share Model (KSL672N)
1) Description-The function of the Load Sharing Module is to proportionally share load between two or more generator sets while the system frequency is held constant. As an accessory to the electronic Governing System, the KSL 672 measures the true power current , and throught a parallel cable interconnection, continuously controls the governor system.
2) Performance
Load SharingAdjustable to within +/ -2% between sets
Performance. Isochronous and droop paralleling and power control
Reverse Power Monitor. Adjustable from 0.5-20% with a 2 second inverse time constant
Forward Power MonitorONtrip point adjustable from 20-100%
OFFtrip point adjustable from 0-80%
Normally open contacts with a 2 second inverse time constant
3) Power Output
Signal. 0 to 7.5 Volts DC representing 0-100% load
All performance specifications are based on 5 amps from the current transformer (CT) Secondaries at full load unity P.F.
4) Power input
AC input signals. . 208 or 416 volt nominal line to line and 5 amp CTs with a minimum 6.25 VA rating. Internal 0.25 ohm burden resistors
Line to line voltagesper table below
HZ LOW RANGE HIGH RANGE
50 140-250 VAC 260-420 VAC
60 170-260 VAC 340-500 VAC
400 170-260 VAC 340-500 VAC
DC Supply. . 18-36 VDC (Transient and reverse voltage protected)
DC Power Consumption. 70 ma continuous
5) Weight: 2.41kg
6) Relative products:
KSL672
KSS6714











