新21 LED PIR运动传感器太阳能壁灯330Lumens超亮度

本产品是节能运动激活的太阳能墙灯。通过使用太阳能发电和锂电池技术，这种太阳能灯被广泛用于入口，走廊，通道，庭院，楼梯，车库等。易于安装，无需电线。

白天，安装在每个灯顶部的太阳能电池板将为电池内部充电。在灰尘中，21LED将使用来自太阳的储存能量自动启动。当检测到运动时，PIR（被动红外）技术将使LED能够转到最大亮度（250-330Lumen）。它为您的家庭和花园带来了很多安全性，安全性和便利性。

功能

1.本产品有一个光传感器，每天自动打开和关闭。当周围的灯光超过100LUX时，产品自行开始充电。当周围的灯光低于100-10LUX时，灯会自动亮起。

2.多功能，本产品有3种模式，按开关一次可依次更改模式。三个指示灯对应3个工作模式。

（1）绿色指示灯亮起：运动传感器加暗灯模式。昏暗的光线（约20LM）始终在夜间穿透。当人们靠近灯光时，运动传感器被触发并变得非常亮（250LM），持续时间达到37秒，然后转向昏暗的灯光。运动每晚最多触发160次。

（2）蓝色指示灯亮起：运动传感器模式。当人们靠近灯光时，它逐渐变亮（约330LM），持续37秒。没有动作，灯熄灭。

（3）红色指示灯亮起：始终开启模式，前5小时亮起强光（约80LM），下个小时变暗（约40LM）。

该产品具有21个明亮的LED，使用寿命超过50,000小时。

4.本产品由一个锂电池供电＃18650 3.7V 2600mAh，电池用完后请更换电池。

安装

1.选择所需的位置，根据上述图片的尺寸钻3个孔。放塑料锚

2.首先将螺钉插入墙壁，将螺钉5-8毫米从表面突出。通过将安装的螺钉上的后盖上的锁眼1钩住，将光固定在表面上。

3.然后从前面安装螺钉2和3。

维护和关注

1.在使用太阳能光源的第一层之前，将光线直射阳光照射约36-48小时。在阳光直射后，光线将达到最佳的光输出。

2.请保持太阳能电池板的表面清洁，以确保产品的工作性能达到最佳。

3.将光线安装在每天接收充足阳光的地方很重要。远离树木，建筑物等造成的阴影。阴凉处不会让电池充满电，并可减少夜间时光。

该太阳能灯包括内置的光电传感器，可以检测周围的自然光线的水平，并控制光线何时自动开启和关闭。太阳能光源应放置在距离其他日光灯源不远的地方至少2米处，因为这可能会使太阳能灯在黄昏时自动开启。

太阳能灯的性能取决于地理位置，天气条件和季节性阳光的可用性。在阴天和冬季，太阳光将不会受到太阳直射，导致亮度降低和操作时间缩短。

NEW 21 LED PIR Motion Sensor Solar Wall Light 330Lumens Ultra Brightness

This product is a energy saving motion activated solar wall light. By using solar power and Lithium battery technology, this solar light it is widely used for entrance, corridors, passages, courtyard, stairways, garages etc. It is easy to setup and no wire needed.

During the day, the solar panel fitted on top of each light will charge the battery inside. At dust, the 21LEDs will activate automatically using the stored energy from the sun. The PIR(Passive Infrared) technology will enable the LEDs to turn to maximum brightness (250-330Lumen) when motion is detected. It brings a lot safety, security and convenience for your home and garden.

Function

1. This product has a light sensor, it turns ON and OFF automatically everyday. While the surrounding light is over 100LUX, the product begins to charge by itself. While the surrounding light is below 100-10LUX, the light turns on automatically.

2. Mulit-function, this product has 3 modes, press and release the switch once to change the mode in turn. Three indicator lights correspond to 3 working mode.

(1) Green indicator light turns on: Motion sensor plus Dim Light Mode. Dim light (about 20LM) is always on through out the night. While people come close to the light, motion sensor is triggered and become very bright (250LM) and last up to 37 seconds, and then turn to dim light. Motion triggers maximum 160 times every night.

(2) Blue indicator light turns on: Motion Sensor Mode. When people come close to the light, it turn on very bright gradually (about 330LM) and last 37 seconds. Without motion, the light turn off.

(3) Red indicator light turns on: Always on Mode, Strong light (about 80LM) for the first 5 Hours, dim light (about 40LM) for the next hours.

3. This product features 21 bright LEDs, lifetime is over 50,000 hours.

4. This product is powered by one Lithium battery #18650 3.7V 2600mAh, Replace the battery after they run out.

Installation

1. Choose the desired place, drill 3 holes as per the dimension of the above picture. Put the plastic anchors in.

2. First insert the screw into the wall and leave the screw 5-8mm to project from the surface. Fix the light to the surface by hooking the keyhole 1 at the back cover over the mounted screw.

3. Then mount the screws 2 and 3 from the front.

Maintenance and attention

1. Before use the solar light for the first tiime, leave the light under direct sunlight for about 36-48 hours. The light will achieve optimum light output after the enormous exposure to the sunlight.

2. Please keep the surface of the solar panel clean, to make sure the product works at it's best performance.ance.

3. it is important to install the light in a location that receive full sunlight each day. away from the shade caused by trees, buildings etc. Shady locations will not allow the battery to be fully charged and will reduce the hours of night time light.

4. This solar light include a built-in photo sensor, which detects the level of surrounding natural light and controls when the light will automatically switch on and off. The solar light should be placed at least 2 meters apart from on another and away from other nikght time lights sources as this might keep the solar lights from automatically turning on at dusk.

5. The performance of the solar light is dependent on the geographical location, weather conditions and seasonal sunlight availability. On cloudy days and during winter, the solar light will not receive as much direct sunlight, resulting in reduced brightness and reduced operating time.