SX460调压器是一种密封式电子设备，通过调节发电机励磁电流来稳定无刷发电机的输出电压
技术参数：
检测和电源输入：电压95-132V AC或190-264V AC单相桥式铜套


现场输出：频率50 / 60Hz，设定铜线上的电压207V交流输入最大90V直流
电流连续4A，不连续10秒10A电阻最小15欧姆

外部电压调节：±7％，1K欧姆1W电位计
电压慢建立时间：2秒
电压调节精度： <± 1.5% (at generator change <4%)
电压建立：AVR输入端需要高于5V AC的剩磁电压
温度稳定性：每℃变化，电压漂移0.05％
功耗：高达10瓦
低频保护：出厂转折点值：95％Hz
斜率：170％降至30Hz
尺寸：135mm L * 100mm W * 49mm H
重量：243克±2％
2.接线：
2.1将发电机的激励场引线连接到F +和F-连接器
2.2连接检查电源线在7,8（出厂设置220V，如果需要设置110V，请3,4短路）
2.3外部稳压器（根据需要）
2.4选择50Hz或60Hz
2.5选择RST三相电压
注意：建议使用更高的中断容量的保险安装在电源中，保险丝的容量应根据实际全励磁电流的120％

SX460 voltage regulator is a sealed electronic device, by adjusting the generator excitation current to stabilize the brushless generator output voltage
1. Technical parameters:
Detection and power input: voltage 95-132V AC or 190-264V AC single-phase to bridge copper set


Field output: frequency 50/60Hz to set the voltage across the copper 207V AC input maximum 90V DC
Current continuous 4A, discontinuous for 10 seconds 10A resistance minimum 15 Ohms

External voltage regulation: ± 7% with 1K Ohms 1W potentiometer
Voltage slow settling time: 2 seconds
Voltage regulation accuracy: <± 1.5% (at generator change <4%)
Voltage establishment: The AVR input terminal needs the remanence voltage above 5V AC
Temperature stability: change per ° C, the voltage drift of 0.05%
Power consumption: Up to 10 Watt
Low frequency protection: factory turning point value: 95% Hz
Slope: 170% down to 30Hz
Size: 135mm L * 100mm W * 49mm H
Weight: 243 grams ± 2%
2. Wiring:
2.1 Connect the excitation field leads of the generator to the F + and F-connectors
2.2 Connection check the power cord at 7, 8 (factory set 220V, if you need to set 110V, please 3,4 shorted)
2.3 External voltage regulator (as required)
2.4 Select 50Hz or 60Hz
2.5 Select RST three-phase voltage
Note: It is recommended to use a higher interruption of the capacity of the insurance installed in the power supply, the fuse capacity should be based on the actual full field current of 120%