Material requirements :High strength cast iron HT200-300,Stiffness :HB170-240.

Cast iron platform machine flat artificial annealing :In tempering furnace after 600-700High temperature annealing and aging.

Cast iron platform machine flat natural aging :According to the international standards should be 2-3Years of natural aging ,Because this process takes too long ,Business has been affected by the liquidity could not wait so long ,Vibration induced by vibration aging in place. Although the effect of this process is not clear ,But at the international level were in widespread use.

Machine cast iron platform flat Chlamydia trachomatis and the stoma :0Level and 1Platform does not allow air holes and Chlamydia trachomatis ,2Level and 3Level can fill the hole with material solids with platform trachoma. Attention :Filler hardness hardness must be less than the platform itself.

Cast iron plate scraping platforms machine tools technology :Manual scraping in machining process of cast iron platform is the most important process ,It determines the flatness of cast iron platform size ,As well as the contact points of the face. 0Level platforms on each side 25Mm square within the range of not less than 25Point ;1Level platforms on each side 25Mm square within the range of not less than 20Point ;2Level plate on each side of the platform for 25Mm square within the range of not less than 16Point ;3Level plate on each side of the platform for 25Mm square within the range of not less than 12... Scraping after the completion of the four edges of the platform abate.

Cast iron platform machine plate cleaning and painting :Platform bottom cleaning, thoroughly ,Clean and spray red paint. Side to flat before painting ,Basket paint or coating of green paint.

Cast iron platform machine flat pack requirements :Mainly for wood packaging ,Try to use thicker wood covering platforms face ,Hermetic packaging, if necessary. Platform face the antirust measures must be done well before packing.

Cast iron platform machine Tablet Accessories selection :Main support Choose ,Support materials for wall thickness 1.5-2mm Steel and iron ,Weld density and structure should be rationally ,Adjusting bolt to rotate smoothly.