And teach you how to tap the purchase method:

His appearance

Good mixer chrome-plated surfaces are very finicky, typically go through several processes to complete. Resolving faucet is good or bad depends on the degree of light, the smoother the surface, the bright representative of the quality the better.

Turn the handle

Good mixer when the rotating handle, no excessive clearance between tap and switch, easily open and close the open, does not slip. Bad faucet not only gap, blocked also.

Sound

Leader material is most distinguished. Good mixer is the whole cast copper, beat up sound dull. If the sound is very crisp, it must be of stainless steel, is poor quality up a notch.

Our production process:

And teach you the leading daily maintenance tips:

1.New homes when the faucet is installed, you must first water rinse the sand and impurities in the pipe. To avoid blocking the water.

2.High-end mixer must be experienced and qualified professional installation, install the faucet will not function with a hard object while knocking, you cannot hit a cement, glue, paint wear,

Decay, corrosion leading surfaces of objects.

3.Leading after a long time, water may decrease available special tool unscrew aerator, cleaned filter then carefully back into the can.

4.Open and light off important, any reckless, especially hard action has the potential to undermine a leader's seal is causing the failure.

5.Leading to regularly with a soft cotton and wipe to ensure that leading glossy, try not to use detergent cleaning, never use corrosive acids and alkali solution.

Teach you methods that handle faucet:

In the normal course of life, sometimes found that tap water in the wake of tightening will still drop, and drops from the faucet outlet or connector on,

Not only a waste of many, sometimes the noise would cause some troubles. In fact tap structure is very simple, leak repair is complete you can fix your own look

In General, the leaking problem as long as the axis of change inside the faucet gaskets or triangle gasket gasket parts of a class, can be resolved. But before refurbishment

Always switch off taps in the House.

Repair faucet leaks at the joint, the reason is tied to tap part of leak (screws) waterproof adhesive tape damage. So anyone with a wrench

Tap Remove fixing screw d on the place where the volume of new sealing tape, for repair of the following steps: first, first tap fastening, tap with a wrench to

Counterclockwise rotation off. Second, the threaded hole to the outside, printed tape clockwise in the threaded portion of the wind on the volume 5-6Back to the.

Is the tap adjust the water tied tied the wrench clockwise into the final after the installation is complete, open the switch to try and confirm if there will be leaks.

Contact us now ...