Have to teach you the leading daily maintenance tips:

1. New house installation faucet, you must first drain the pipeline in the sand and impurities, so as not to block the impact of water.

2. High-end faucet must be experienced and qualified professionals to install, install the lead can not be bumped with a hard object, can not touch the cement, glue, paint, wear, corrosion, corrosion faucet surface objects.

3. Long after a long time, the water may be reduced, you can use a special tool to unscrew the bubbler, clean the filter and then carefully put back.

4. Light to open the light off is particularly important, any reckless, deliberately straining the behavior are likely to damage the seal leading to failure.

5. Faucet should always use a soft cotton and water to clean, to ensure the leading glossy, try not to wash liquid detergent, absolutely can not use corrosive acid solution.

Have to teach you the faucet Buying method:

Look at the appearance

Good faucet surface chrome plating process is very particular about, generally after several processes to complete. Distinguish the faucet is good or bad depends on the degree of light, the surface is smoother the more representative of the better quality.

Turn the handle

Good faucet in turning the handle, the leading and the switch between the gap is not excessive, and off open easily, do not slip. Can not only poor-quality tap gap, blocked sense is also large.

Listen to the sound

The leading material is the most difficult to distinguish the good leader is the overall cast copper, beat up the sound boring if the sound is very crisp, it must be stainless steel, the quality will be a difference of a grade.

Have to teach you to handle the water leakage method:

In normal life, sometimes you will find the tap water will still drip after tightening, but also from the faucet at the exit or a drop of non-stop joints, not only caused a lot of waste, and sometimes its sound will cause some trouble In fact, the structure of the faucet is very simple, leaking maintenance is entirely self - repair to see, in general, the problem of leakage as long as the tap inside the shaft gasket or triangular gasket seals and other types of parts, Can be resolved.However, before carrying out the refurbishment of the home switch off the main tap.

As for the leakage repair of the faucet joint, the cause of water leakage is nothing more than the damage of the sealing tape of the tap part (fixing screw) .Therefore, as long as the faucet is removed with a wrench, it is rewound at the place where the screw is fixed The new water tape can be, the following steps for maintenance: First of all, first tap tightly with a wrench to counterclockwise rotation to remove the tap.Finally, the screw hole out, in the threaded part of the wind with India Tape the tape clockwise 5-6 back.

To see if there is adjustment of the tap a good water tied to the clamp clockwise direction, the final installation is complete, open the main switch to try to confirm to see if it will leak.