Coating thickness gauge features

• Using both magnetic and Eddy current thickness measurement method, non-destructive measurement
  1. Magnetic substrates (steel, iron, alloys, etc) on non-magnetic coating thickness (such as zinc, aluminium, chromium, copper, rubber, paint, etc)
  2. Non-magnetic substrates (such as copper, aluminum, zinc, Tin, and so on) on non-conductive coating thickness (such as rubber, paint, Anodic oxidation film)
• With two measuring modes: continuous measurement (CONTINUE) and the single measurement mode (SINGLE)
• Has two operating modes: direct method (DIRECT) and a burst mode (Appl)
• Five statistics: averages, maximum (MAX), minimum (MIN) and the number of tests (NO.) and the standard deviation
• Two methods can be used to calibrate instruments, and basic calibration of probe system error correction
• With storage function: you can store 500 measurement values
• Delete function: to delete the occurrences of a single suspect in the measurement data, you can also delete all the data within the storage area
• Limits that can be set: automatic gauge measuring value outside of alarm; And histogram analysis of the measurements
• Print: printable measurement, statistics, and bound histogram
• Has the PC communication function: can be measured, statistical value transmitted to the PC, so that the data can be further processed
• With low supply voltage indication
• Procedure beep tips
• Has an incorrect function through onscreen or beep error
• A shutdown in two ways: manual shutdown mode and the automatic shutdown mode

• Coating thickness Tester technical parameters

• • Probe type: f | N
  • Measuring principle: inductive | Eddy
  • Measuring range: 0-1250um | 0-1250um 0-40um (copper chrome)
  • Low resolution: 0.1um
  • Probe connector: integration
  • Indication error: f | N
    1. Calibration (UM): ± (3%H+1)
    2. Two-point calibration (UM): ± ((1%~3%) H+1)
    1. Calibration (UM): ± (3%H+1.5)
    2. Two-point calibration (UM): ± ((1%~3%) H+1.5)
  • Measuring condition: f | N
    1. Minimum curvature RADIUS (mm): convex 1.5 | 9,
    2. Matrix minimum diameter (mm): ф 7
    3. The critical thickness (mm): 0.5
    1. Minimum curvature RADIUS (mm): convex 3 | 10,
    2. Matrix minimum diameter (mm): ф 5
    3. The critical thickness (mm): 0.3
  • Temperature and humidity: 0~40℃ | 20%RH~ 90%RH
  • Statistics: averages, maximum (MAX), minimum (MIN) and the number of tests (NO.) and the standard deviation
  • Work methods: direct method (DIRECT) and a burst mode (Appl)
  • Measuring mode: continuous measurement (CONTINUE) and the single measurement mode (SINGLE)
  • Minimum settings:
  • Storage capacity: 500 measurements
  • Print/computer:/optional printer cannot connect to computer
  • Shutdown mode: manual and automatic
  • Power supply: two AAA type (7th) 1.5V battery
  • Overall dimensions: 110x50x23mm
  • Weight: 100g