Stainless steel faucet:

Stainless steel faucet safety lead-free, non-corrosive and exudate, no smell or turbidity problems, will not cause secondary pollution of water quality, maintain clean water sanitation, health and safety to achieve complete assurance.

Field corrosion test data show that the service life of stainless steel up to 100 years, almost no need to maintain life cycle, to avoid the cost and trouble of leading the replacement, operating costs low.

Stainless steel faucet with the same building life.

Have to teach you the leading daily maintenance tips:

1. New house installation faucet, you must first drain the pipeline in the sand and impurities, so as not to block the impact of water.

2. High-end faucet must be experienced and qualified professionals to install, install the lead can not bump with hard objects, can not touch the cement, glue, paint and other wear and tear,

Corrosion, corrosion of the faucet surface of the object.

3. Long after a long time, the water may be reduced, you can use a special tool to unscrew the bubbler, clean the filter and then carefully put back.

4. Light to open the light off is particularly important, any reckless, deliberately straining the behavior are likely to damage the seal leading to failure.

5. Faucet should always use a soft cotton and water to clean, to ensure the leading glossy, try not to wash liquid detergent, absolutely can not use corrosive acid solution.

Have to teach you to handle the water leakage method:

In peacetime life, and sometimes will find the tap water after tightening or dripping water, but also from the faucet outlet or a drop at the junction of non-stop,

Not only caused a lot of waste, and sometimes its sound will cause some trouble.In fact, the structure of the faucet is very simple, leaking maintenance is entirely self-repair to see,

In general, the problem of leakage as long as the shaft into the faucet within the gasket or triangular gasket seals and other types of parts, you can be resolved.But before the renovation

Turn off the main faucet switch at home.

The reason for the leaking repair of the faucet joint is that it is caused by the damage of the sealing tape of the tap part (fixing screw) .Therefore,

Remove the faucet from the place in the fixed screw re-wrap the new tape can be water, the following steps for maintenance: First, the first tap tightly, with a wrench to the faucet to

Counterclockwise to remove the second way, the screw hole out, in the threaded part of the wind tape with the clockwise roll 5-6 back.

To see if there is adjustment of the tap a good water tied to the clamp clockwise direction, the final installation is complete, open the main switch to try to confirm to see if it will leak.

Contact us.