Welcome to the shop

Welcome to the shop

Welcome to the shop

Welcome to the shop

Welcome to the shop

KLD-V3 Screw Arrangement Machine Key Function Instructions:

Key Function Assignment A: 1, clear the counter 2, press the first time plus 1.

Press the key to assign B: 1, set the number of settings 2, press the next time the number minus 1. 3, reset to 001.

Key function to assign F: 1, enter the function. 2, determine the exit.

A key to clear the function to use

In the normal state, press and hold A, enter the counter clear function.

B key fixed function to use

Press B in the normal state, enter into the counter setting function, enter 0000 after the program, press A to add 1, press B to reduce the number of 1, set the number and press F to exit.

After setting the user to set the amount of consistent, the machine rings the buzzer, automatically reset the counter, automatically enter the next fixed number, and then cycle. (Note that in the new power off or power on After the fixed number of functions automatically shut down)

F key function to use:

First, the expected delay to stop function to use.

Press F, then press F to start the program, and it will display as F ### (F000-F255), the bigger the number, the longer the delay. Reset to F001. General It is recommended to set F009 or less.

The function of this delay function is that when the user is using, it is found that the screw feeding is slower, which causes the customer to take the screw in place after a certain time, so that the user waits for the screw to be in place and waste Working time. At this point it is recommended to lengthen the expected delay to feed F ###. (Recommended within F050)

The shortcoming of this function is that if the delay time is too long, the rear screw on the rail will push the front screw and the pad screw will be caused by the pushing force.Therefore, as long as the screw supply is sufficient, Try to adjust small.

Second, in the normal boot, hold down F, enter the sensor control accuracy setting function method.

After confirming that there is no screw in the front of the rail, press and hold the button F until AA ## (must be between AA50 and AA05). Please note this data, then press the button F once again, the display will show Sd ##. Press F once (you must press the F button in this order), the machine automatically calculate the data, automatically returned to work normal, normal use of the machine.

Welcome to the shop