Precision deflection tester For the detection of precision instruments, mainly used to detect shaft, disk type of parts of the radial, round beating and round face beating. Partial pendulum made of high-quality materials, materials Ht200, Hardness Hb170-240.

Partial pendulum check the main technical parameters:

1, Mohs No. 2 60 ° conical surface of the Mohs cone radial radial runout ≤ 0.005mm

2, the axis in the 100mm range of the parallelism of the rail (horizontal vertical direction) ≤ 0.006mm

3, the measured diameter of 170mm-460mm parts

4, measuring the length of 300mm, 500mm, 1000mm, 1500mm .2000mm.

Note:

1. Partial pendulum check instrument is a sophisticated detection equipment, the operator must master the operation skills of the instrument, carefully maintenance, and designated person to use.

2. Bias check device must always keep the equipment intact, equipment installation should be balanced and reliable, the guide surface to be smooth, no bumps scars, two top coaxial tolerance should L = 400MM range a and b are less than 0.02MM .

3. Before the workpiece inspection should be used L = 400MM test rod and dial gauge accuracy of the partial calibration apparatus to ensure that qualified before use.

1. The workpiece detection, should be handled with care, rail surface is not allowed to place any tools or parts.

Second, the workpiece detection is completed, the instrument should be immediately carried out maintenance, rail and the top sets of oil rust, and keep the surrounding environment clean and tidy.

Third, the person should be designated at the end of the end of the partial pendulum instrument for precision measurement inspection to ensure that the equipment in good condition, and make the measured record.

Partial pendulum inspection instrument packaging: wooden box (can also be customized according to user requirements)

Partial pendulum check the color of the instrument: Bias pendulum check the general choice of green and blue (also according to user requirements)