Precision deflection tester For the detection of precision instruments, mainly used to detect shaft, disk type of the other parts of the radial, round beating and round face beating.

Note:

1.Partial pendulum check instrument is a sophisticated detection equipment, the operator must master the operation skills of the instrument, carefully maintained, and designated to use.

2.Partial pendulum check device must always maintain the equipment in good condition, equipment installation should be balanced and reliable, guide surface to smooth, no bumps scars, two top coaxial tolerance should be L = 400MM The range aTo and bTo are less than 0.02MM.

3.The workpiece should be tested before use L = 400MM Check the rod and the dial gauge to check the accuracy of the device, to ensure compliance, before use.

one . Workpiece inspection, should be handled with care, rail surface is not allowed to place any tools or workpieces.

two . After the completion of the workpiece detection, the instrument should be immediately carried out maintenance, rail and top sets of oil rust, and keep the surrounding environment clean and tidy.

three . Should be designated by the end of each month on the partial accuracy of the device to check the inspection to ensure that equipment in good condition, and make the measured record.

Partial pendulum inspection instrument packaging: wooden box (Can also be customized according to user requirements)

Partial pendulum check the color of the instrument: Bias pendulum check the general selection of green and blue (Users can also request)

Partial pendulum check instrument The main technical parameters:

1, Mohs 2number 60 °Radial Circular Run of Cone to Morse Cone ? 0.005 mm

2, Axis in the 100 mm Parallelism of the guide rail (Horizontal and vertical direction ) ≤ 0.006 mm

3, The measured part diameter 170mm-460mm

4, Measuring length 300 mm , 500 mm , 1000 mm , 1500 mm.

Gear beating tester ring gear radial runout ? Fr , In the range of a gear, the probe in the slot teeth or gear, and the middle of the tooth high-sided contact, the probe relative to the gear axis of the most amount of activation. The original rack-shaped measuring head when the line, as shown in the diagram for the principle of this inspection device.Check, will be installed on the mandrel of the inspection gear, set in the instrument between the two thimble, the original The rack-shaped measuring head is inserted into the teeth of the gears in turn and indicates the amount of jerk of the measuring head position to the gear rotation axis.

The gear beating checker is used for inspection 6Level or 6Level below the accuracy of cylindrical, conical external gears and worm gear radial runout or end beating.