MZ-10Single, three-phase synchronization indicator instructions

one, MZ-10Rated voltage is 100V, The frequency is 50HZ.

two, will MZ-10Of the money column A, B (Three-phase A, B, C) According to the instrument attached to the line diagram, with a wire connected to the motor to be complicated A, B, (Three-phase for A, B, C) Side, will A. , BThe terminal is connected to the normal operating grid by a wire A. , B. versus A. , BConnect a double - pole single - gate switch according to the wiring diagram.

three, Disconnect before use A. , BAfter completion of this step can be activated to be concurrent motor, and adjust the motor speed and voltage to be concurrent observation MZ-10Frequency difference and voltage difference table, so that the instrument pointer is basically pointing to zero scale.

four, The double-pole single-gate switch to pull A. , B., While observing MZ-10Middle STable of the steering speed, and continue to adjust the motor speed and voltage to be made, so that the frequency difference and the voltage difference meter pointer points to zero, this time MZ-10Middle SThe table will be very slow rotation, when the pointer points to the synchronization point, you can be complicated with the motor and run the grid and run the grid.When the completion of the grid, please disconnect the double knife single-gate switch.

Fives, MZ-10Front Size: 200 * 80mm,Mounting Hole Size: 191 (width) *71 (high) Mm.