Shop hot! Explosions featured! This winter than him!

Auto Accessories head ornaments cute spring head creative ornaments resin car ornament/2645-1

¥11.40

Universal car down in autumn and winter three-piece cushion car seat without backrest seat cover 64-3C/5168

¥120.00

Value meal shake dog ornaments 250+ electrostatic stickers 734+ mat 749 T/1692

¥12.60

Car pendants gourd supplies Ferro safety rear view mirror hanging Crystal decoration/2641

¥14.60

Factory direct car crash car scratch-resistant rub-rub-proof adhesive tape universal t/2156

¥14.30

Cross-generation winter plant tomentose down lumbar cushion lumbar pad gift T13-2A/997

¥8.60

"Name": car door handle protection film

"Color": transparent
"Material": OPVC is colorless and transparent (polyurethane)
"Dimensions": 9.5cm*8.5cm
The "weight": 18g
"Packaging": as shown in the figure
"Packing": 7.8*11.8cm
"Packing": 2000/piece
"Carton": 47*40*30

This product is used for high copy pasted firmly installs the correct circumstances not yellow is not hard

Machine finishing a cutting edge curvature does not have dead paste firm

"Description of goods": clean the scratch-proof, anti-fouling corrosion protection, radiation protection, enhance appearance; Super tough, scratch-resistant wear, experiment, perfect care, bright and clear, simple construction

"Attention": when used with water must be sprayed on the door handle, which is designed to prevent stuck crooked, sprayed with water can be amended in a timely manner! Within 2-3 days of the post please don't rain and car wash

Product features:

This material is colorless and odorless absolute transparency, suitable for use in any color car. 0.3mm thickness and superior toughness, does not break, scratch-resistant, affixed to the door at the bowl, can fully protect car paint, avoid frequent switching doors lead to fingernail scratches, this product is colorless and odorless transparent body, high viscous 1mm2/110 Newton. High temperature 140 degrees Celsius, cold-60 c does not break. Resistance to acids and bases. Water impact-resistant 2-4MPA.

Use method
1. Please wipe clean grip concave (has been scratched, but needs head protection, with sand before using the wax on the concave, the effect will be even better).
2. peel off foil, with water sprays, adhesive side, concave evenly and handle small amounts of fog.
3. allow the glue surface close to the concave, slide up and down, adjust, and location.
4. the surface between the two thumbs pressed into ' a ' words gradually to advance on both sides, squeezing out of the water.
5. fingers squeezing the Middle pushed flat on the surface, gradually phased out, in case of tilted or folded, with a hot hair dryer (low temperature) heat, and heal.