305#Impact Tester (Wegner Type )Designed to comply with DIN 51 155To test enamel (Glaze).

The portable handheld devices can be deposited in any suitcase, avoiding the removal, transportation, and many other problems. Can be used outside the laboratory workshop, the workshop experiments. So tests can be used in the specified location, test objects, this is the only instrument to test large bulky test equipment for which good test place.

305#Impact test is suitable for plastic surface test, the test must be compatible with a special bracket.

Test procedures

In order to set up test instrument, rotate the handle until the pointer turns into a desired test pressure value readings from the vertical scale (0~90N)And on the tape at the handle for 1NRead on a transitional value. In contrast, reliable values shown on the longitudinal scale unit Nm Any interim values are estimates.

When a spring is stretched, shock screws have to be pushed back until it is locked.

Test, the tester must be perpendicular to the test surface, static testing head on the enamel surface, plane test head and two legs forming a tripod when on uneven surfaces, legs may become an obstacle, if necessary by adjusting the three embossed screw the legs removed or turned to the side.

When testing the edge, edge test points are placed in a vertically-mounted slot.

Test pieces shall be placed in and real as possible inconsistencies, especially for those small, light objects do not press too hard.

Screwdown card lock card, completed impact test shock screws.

Beware

When test pressure is greater than 30NThe impact bolt should always be on a sample, not should not impact specimen.

Technical data:

Measuring range : 0~90N (Continuously adjustable)

Punch diameter : 5mm

Tool length : 245mm (Not tight)

Net weight:

Instrument : About340g

Enamel testing Board : About25g

Plastic surface test stand (f120mm ) : About3000g

Tensioning device : Mechanical type

Locked card : Mechanical type