Shanghai macro ETCR035AD AC/DC clamp current sensor

1+	580 CNY (84.45USD)
2+	550 CNY (80.09USD)

Product parameters:

Technical specifications

Function	AC and DC current, phase, power, power, power factor, car batteries and other testing
Power supply	6LR61 9VDC (plugged in)
Rated power	5mW
Measurement mode	Clamp CT, non-contact measurement
Jaw size	30mm×35mm
Range	0.0A~ 1000A AC/DC
Resolution	0.1A AC/DC
Signal output	1mV/1A 0~ output 0~ 1000mV 1000A correspondence DC/AC
Accuracy grade	± 1.0%FS (23 ℃ ± 2 ℃, 70%RH, and conductor at the Centre jaw position)
Phase error	≤3°(AC 50Hz/60Hz; 23℃±2℃)
Zero	Press the ZERO key to zero and eliminate the effects of magnetic field on DC detection
Cable and plug	Output lines: RG-58A coaxial cable, cord length 2m; Connector: BNC (customer requirements can be assembled plug)
Wire location	Are testing wires in jaw position off center position error of increase 1.5%RDG
Frequency response	AC: 45Hz~ 400Hz
Line voltage	AC/DC 600V circuit testing
Battery voltage	When the battery voltage drops to 7.2V, the battery low voltage LED lights, reminds battery replacement
Meter size	Length: 122mmx width 70mmx thickness 33mm
Appearance quality	180g (including battery)
Working temperature and humidity	-15 ℃ ~ 45 ℃; 80%RH the following
Storage temperature and humidity	-10 ℃ ~ 60 ℃; 70%RH the following
Dielectric strength	AC 3700V/rms (between the core and shell)
For safety	IEC1010-1, IEC1010-2-032, pollution etc 2, CAT III (600V)
Supplied accessories	Sensor 1, battery (6F22 9V) 1, user manual, warranty card

Clamping current sensor category