AC cam controller model range of manufacturers supply, many models have, contact customer service: 13587450647 or Miss

KTJ1Series Cam controller Used crane AC motor starting, speed and directional control. The rated current of the controller into 50Ease 80And according to the different line count types, most of the controller circuit with inverse symmetric and can be used for crane translation mechanism can be used for crane lifting. KTJ1-50/1, KTJ1-80/1, KTJ1-80/3, KTJ1-50/4, KTJ1-50/6Controller for the control of three-phase wound-rotor asynchronous motor. KTJ1-50/2, KTJ1-50/5Controller for simultaneous control of two three-phase wound-rotor asynchronous motor. KTJ-50/3Controller for the control of three-phase squirrel-cage induction motors.

1. Architecture overview

Controllers made the protection, the borrowing of movable cover to prevent touching live parts.
Controller (see Figure 13) Shell from within by cam components (2), Formed by contact and moving contacts. Components installed in the cam angle (5), The insulation support (6) Fitted with a static contact (10) And mass (11), The moving contact of the lever (7) One end fitted with moving contact (8), The other fitted with roller (9), The shell by cam (4) And the axis (3) Consisting of cam drum.
Break the rotor circuit or contact parts of the cam component of the stator circuit made of asbestos cement chambers (13) Interval, the Chamber is mounted on the shaft (12), KTJ1Series controller line cam cam components components and power lines in addition to KTJ1-50/5, KTJ-80/1, KTJ-80/3Other than all the others the same.
To make the cam on the drums stopped at the desired position, and the latch mechanism to perform, body positioning wheels (14), Locator (15) And spring (16).
Operations controller is borrowed and cam drum to the handwheel, the introduction of wire through holes into the base under the controller.
Controllers can be fixed to the wall, any location on the Bay, it has special holes for installation, special screws for body is provided with grounding, handwheel grounding through the cam ring.
When you turn the balance wheel, cam pressure roller, and turns the lever, mounted on the lever the moving contacts are also turned on.
Continue turn lever then contacts separate.
Close contacts in the opposite order, turn the balance wheel, after leaving the roller cam, springs will be the top back in place.
Moving contact of the rotation of the lever is the contact of excess travel, whose role is to contact wear when contacts are still necessary to pressure.