Rocker drill table Uses: mainly used for drilling work, the top T-slot, used to fix the workpiece, and clean up the processing of iron scrap. Manufactured according to JB / T7974-2000 standard products made of ribbed plate and box-type.

Radial drilling machine table Material: high strength cast iron HT200-300 face hardness HB170-240, after two manual processing (artificial annealing 600 degrees -700 degrees and natural aging 2-3 years) using the product accuracy and stability, good wear resistance.

Casting process: Rocker drilling table using advanced vacuum sand casting process, product yield is high, low cost, casting is not easy to appear pores, trachoma.

Rocker drill table And the stiffness of the structure is calculated by the finite element method of the space combination structure.

Drilling table Model 1000 * 800 * 560 500 * 500 * 630 400 * 400 * 630 450 * 450 * 630 750 * 500 * 500 (special-shaped table can be customized to map)

Machine tool test box also known as the square box box for the parallel parts of the boring machine, the vertical test and support the workpiece when the crossed, usually the same side of the cube or rectangular box.Test box according to JB / T3411.56 -99 standard manufacturing, material HT200. I plant machine tool test case casting castings using HT200-HT250, the second tempering treatment to ensure that the casting stability and hardness.

1. Machine test mattress Uses: Boring square box is mainly used for parallel parts, such as the vertical test and crossed. Boring box is made of cast iron concrete cavity of the six square cube, one of which V-groove on the working surface.

2. Machine test box requirements: Boring box side of the face can not have rust, scratches, cracks, sags and other defects affect the measurement performance.Non-face should be sand painting, edge chamfer. Inner wall should be signs, and marked with the size specifications, the level of factory number, manufacturer name.

3. Machine test box pad accuracy: for scratching the development of square box in addition to the test flatness, but also with the color method to test contact spots in the side length of 25mm random squares within the number of points: 1, 2 less than 25 Point; level 3 not less than 20 points.

Cast iron pad features: large heavy bulky workpiece, do not flip the workpiece, the first corner box position is adjusted, and then bottom of the drawer plate on the vertical side of the vertical box, you can draw the vertical line on the workpiece; Can also be used to increase the height of the needle plate and height gauge; also by means of C-shaped clamp, the workpiece will be tightened on the right angle box, the crossed.