Radio Receiver/Transmitter, 220 to 2 Zone which Control AC-powered Garden Lights

bargain

add to cart

Instruction manual
Included in the pack are already programmed and ready touse
Zones 1 and 2 can operate independently in bistable or timedmode
Setting the mode of operation:
- Zone 1:
  - Bistable: remove the jumper on terminals1and 2
  - Timed: insert the jumper on terminals1and 2
- Zone 2:
  - Bistable: remove the jumper on terminals 2 and 3
  - Timed: insert the jumper on terminals 2 and 3
Radio control acquisition:
- Zone 1:
  - Press key P1 on the control unit once to program exit Z1, theLED will remain on
  - Press and hold the key to be acquired on the radio control unituntil the LED on the
  - main control unit starts to flash ,release the key
- Zone 2:
  - Press key P1 on the control unit twice to program exitZ2, theLED will remain on
  - Press and hold the key to be acquired on the radio control unituntil the LED starts to
  - flash, release the key
Setting the work time: (time the existion)
- Only if timed mode is used
- Zone 1:
  - Press key P2 on the main control unit once to set the work timefor exit Z1, the LED will
  - set on exitZ1, after which press key P2 again
  - LED will flash three times to confirm
- Zone 2:
  - Press key P2 on the main control unit once to set the work timefor exit Z2, the LED will
  - come on
  - Wait a length of time equal to the work time to be set on exitZ2, after which press key
  - P2 again
  - LED will flash three times to confirm
Deleting the radio control codes:
- Deleting an individual code:
  - Press and hold key P1 on the main control unit for 5 seconds(release the key), the LED will
  - remain on
  - Press the key on the radio control unit to be cancelled untilthe LED begins to
  - flash
- Deleting all codes:
  - Press and hold key P1 on the main control unit for 10 seconds,the LED will come
  - on, then release the key
  - LED will emit 3 flashes to confirm the deletion of all the
  - codes