The company operating the FT-106 ordinary abrasive bulk density tester, Pu village, quality assurance, welcome to consult the discussion.

FT-106 Ordinary abrasive The bulk density meter, Abrasive Bulk density meter

FT-106 Ordinary abrasive The bulk density tester (original DMP-II )

FT-106 Ordinary abrasive The bulk density tester According to international standard ISO9136: 1989 (Determination of bulk density coarse grains) and industry standard JB / T7984.2-1999 (Ordinary coarse grit abrasive Determination of bulk density) of the relevant technical requirements of development and production of special detection equipment, while meeting the GB / T20316.1-2009 bulk density tester requirements; suitable for detecting manufacturing bonded abrasives and coated abrasives bulk density of coarse particles of abrasive materials, but also for the detection of other granular material bulk density of the detection method. results and international common detection method has complete versatility.

FT-106 Ordinary abrasive The bulk density tester working principle

The abrasive test load funnel, open the drain valve, abrasive natural port along the funnel and into the measuring cylinder fall, and will fall into the measuring cylinder abrasive Calibrating the balance Weigh Calibrating the measuring cylinder abrasive quality, and then divided by the volume measuring cylinder, can be measured bulk density of abrasive measured.

FT-106 Ordinary abrasive The bulk density tester Technical Parameters

The main technical parameters

1.1 Funnel Material: Stainless Steel;

1.2 funnel Dimensions: Height 240mm; top diameter 160mm; outlet diameter: (20 ± 0.5) mm;

Catchy from the bottom of the funnel and measuring cylinder: (76 ± 1) mm measuring tube size: diameter 64mm; net height 62mm measuring cylinder volume: (200 ± 0.5) cm3 measurement error: ≤ ± 0.02g / cm3.
2.1 Measurement error: ≤ ± 0.02g / cm3.
2.2 measuring cylinder volume: 200 ± 0.5cm3.
2.3 Dimensions: 230mm (length) * 250mm (width) * 425mm (H)

FT-106 Ordinary abrasive The bulk density tester

Note: Specific parameters, please keep in touch with us, as well as related products.

Ricoeur instrument tips: You may be interested in the following products:

Common powder powder tester series

FT-100A Tap density tester; FT-100B tap densitometer; FT-101 Scott capacity meter Bulk Density Tester
FT-102 Hall flow meter / Bulk Density Tester - stainless steel; FL4-1 Hall flow meter / powder flowability tester - brass FT-103 bulk density tester; FT-103A activated clay bulk density determination equipment;

FT-103B Dust analyzer angle of repose; FT-104 Alumina bulk density tester;

FT-104A Repose angle measurement; FT-104B repose angle measurement; FT-104C aluminum fluoride mobility analyzer; apparent active agents tester FT-105A FT-105 Apparent density density measuring device; FT-105B slurry Table View density measuring device; FT-105CASTM plastic apparent densitometer; FT-106 abrasive bulk density tester (Original DMP-II)
FT-106A powder bulk density tester; FT-106B superhard material bulk density tester
FZS4-4 tap density tester; FT-102A vibration funnel bulk density tester

FZ4-3 Bulk density of the funnel-type vibration analyzer; FS4-2 Skoda Bengtsson bulk density tester

DMP-II ordinary Abrasive bulk density tester; FT-107 Fertilizer bulk density (Loose) Tester