SX460 voltage regulator is a sealed electronic device, by adjusting the generator excitation current to stabilize the brushless generator output voltage
1. Technical parameters:
Detection and power input: voltage 95-132V AC or 190-264V AC single-phase to bridge copper set


Field output: frequency 50/60Hz to set the voltage across the copper 207V AC input maximum 90V DC
Current continuous 4A, discontinuous for 10 seconds 10A resistance minimum 15 Ohms

External voltage regulation: ± 7% with 1K Ohms 1W potentiometer
Voltage slow settling time: 2 seconds
Voltage regulation accuracy: <± 1.5% (at generator change <4%)
Voltage establishment: The AVR input terminal needs the remanence voltage above 5V AC
Temperature stability: change per ° C, the voltage drift of 0.05%
Power consumption: Up to 10 Watt
Low frequency protection: factory turning point value: 95% Hz
Slope: 170% down to 30Hz
Size: 135mm L * 100mm W * 49mm H
Weight: 243 grams ± 2%
2. Wiring:
2.1 Connect the excitation field leads of the generator to the F + and F-connectors
2.2 Connection check the power cord at 7, 8 (factory set 220V, if you need to set 110V, please 3,4 shorted)
2.3 External voltage regulator (as required)
2.4 Select 50Hz or 60Hz
2.5 Select RST three-phase voltage
Note: It is recommended to use a higher interruption of the capacity of the insurance installed in the power supply, the fuse capacity should be based on the actual full field current of 120%