Associate marketing, do not delete

Associate marketing, do not delete

Associate marketing, do not delete

(A) ultra wide voltage charging 110V-220V.
(B) you can choose one of three ways of power:

(1) direct charge: special charging cable can be directly connected to the power distribution charge, 4-5 hours to fill.

(2) this paragraph itself baby comes with lithium-ion batteries.

(3) solar power: solar panels with high sensitivity, without the Sun, as long as there is sunlight to recharge.

(4) USB power supply: connect the phone for charging the mobile phone. Connect the charger to recharge itself.

(5) dimensions:

Do not stretch (8*8.6CMX14cm) drawing (8*8.6CM*19cm) bottom diameter 8.6cm portable handle size 10cm

Lights beads: 5 LED bulbs

Charging method: solar-powered direct-filling UBB Jack power supply power supply

Packing: color box with accessories: solar light + a direct charge line + gift box

Product weight: 258g box 315g

(6), packing size: 57*38*47CM (carton)

Note: the stretch open the Lantern, lantern and torch switches on the same switch. This style opening needs to be pressed after the switch will light up.

I. switch instructions for use
1, the battery positive (lamp), negative pole facing out (tail).
2, the switch at the rear, the switch function switch is a switch function, the flick of a switch are dimming.
II. Board instructions
1, our flashlight uses advanced constant-current technique can effectively address the constant-current LED flashlight's requirements.
2, special instruction: a. do not pressure, voltage do not exceed 4.2V b. battery positive forward, not reverse, otherwise it will burn plate c. attention to control the torch temperature changes, ensuring heat d. non-professionals do not open the circuit board.
3, warranty description: open circuit is no longer under warranty or addressed.
III. lithium battery instructions
1, the characteristics of lithium-ion batteries: lithium battery and cell phone batteries charged totally different ways; Lithium-ion batteries do not have memory and can be filled at any time, do not overcharge.
2, charging at least 6 hours for the first time, according to the charger the green light then it is possible, no charge.
3, special tip to use against overcharge, anti-, short circuit-proof ' proof ' charger.
4, the battery is not used for a long time, should save power full, normal charge and discharge about three months at a time.
IV. flashlight specifications
1, torches in use, according to torch the requirements for voltage and battery choice, not to prevent burn circuit boards, different models, different voltage of battery do not use both.
2, in use, when the obvious changes in the brightness of the torch, to turn off the flashlight, preventing battery overcharge.
3, cooling techniques: the torch is in use, to ensure the heat. Strongly required when battery is fully charged, it is best to use second gear, be extended so that we can let the torch lamp and battery life! Torch light cannot be direct human eye, super bright, so as not to affect vision, especially for children.
V. troubleshooting
1, check the battery: make sure battery power and the batteries in the correct direction, do not use different brands of batteries, old and new batteries cannot be mixed.
2, check the tail Cap: make sure switches are tight and in good contact, ensure the tail Cap copper cylinder and the tail cap ring metal contact is good, note that lamp is loose.