Tapping chucks are within the thread machining jigs, a multipurpose tool clamped taps series, variety. are the most common fixture of machining.
Classified according to the caudal Peduncle: the Shanks and Morse taper Shanks
By tapping process can be divided into: rigid, floating (torsion protection)

Morse taper shank tapping chucks:
Outside Morse taper Shanks and Neimo-short taper hole
Tapping chucks components:
1. taper shank 2. Morse Sleeve 3. connecting rod tap 4.7
Use and maintenance:
1. installed Collet Cone and spindle first scrubbed clean, body cone is then mounted on the spindle, with a rubber hammer or gavel tap body end face to ensure close, firm or taut.
2. depending on your machining needs, select the appropriate sleeve scrub clean and within the body into the hole, push the sliding CAP, sleeve Quartet into the square hole of body, clamping tool install clamps on sleeve, and can be processed.
3. If the tapping function, remember that nut first release, processing needs of torque depending on the tap, screw the nut (nut not too tight), tap does not slide.
4. tap when you tap into the sleeve, should pay attention to the shank into the Collet in the square hole of the Quartet, to increase torque.
5. push the slide CAP, then remove the sleeve (or replacement) after use, clean the rust, the main, it tube clips

This product has a floating scale, quick change, torque overload protection features such as taps.

Suitable for drilling, tapping, boring machines, lathes and other equipment for tapping, tapping range M3-M16.