*

Product Name: Bus processing machine: hydraulic separation of copper, aluminum row bending tools
Product Type: CB-150D
Technical parameters: Standard: bending capacity of 150 * 12mm
◎ Applicable to switch box, switchboard automatic control panel wiring works, the use of separate portable;
◎ bent copper or aluminum row bending angle of 90 degrees is correct, does not damage the material from light to copper;
◎ Separate operation, with a variety of pump to operate;
◎ the bending of copper, aluminum row size of the largest 10mm × 150mm;
◎ The machine is equipped with adjustable balance bar to facilitate the use of small copper;
◎ marked on the base of the machine scale, bending angle to the operator to control;
◎ The machine has large tonnage, large bending curvature and good electrical conductivity. The minimum angle of bending is 90 °.
◎ Type Horizontal type latest output 20TON copper width 150mm maximum thickness of 10mm
◎ CB-150D is portable, when bending long copper bar, N-shaped or L-shaped card can be tied
Out of the whole row can be unhindered;
◎ design angle of 90 degrees, 45 degrees instructions, to avoid excessive;
◎ With the pump CP-700, CP-700-2A, DYB-63A, ZCB-700A;