Magnetic GPS position tracking device

User manual

1 Introduction

This product is based on the GSM/GPRS network and GPS satellite positioning system, via SMS or the Internet to locate the remote target or monitor, are the most technically advanced both GPS and AGPS positioning, built-in large capacity battery, standby, free installation + strong magnetic portable GPS Locator.

2 area of application

L/small car rental fleet management

• Outdoor sports

• Children/elderly/disabled/custody of valuables

• Personal safety

• Personnel management

• Tracking and positioning

3 specifications description

4 instructions for use

Please confirm

• Confirm phone card, call, SMS, GPRS Internet access.

• Confirm that there is adequate balance.

• Confirm open caller ID and close the call transfer.

• On first use, please charge for 12 hours or more.

• Correctly insert a GSM SIM card

4.1 place the SIM card

Please be sure to confirm the SIM card don't call forwarding and open the caller ID and PIN code is turned off. Mobile phone text messages must be in plain text format, PDU format is not recognized.

4.1.1 open SIM card soft

4.1.2SIM chip card advance card slot

4.1.3 covered with soft rubber stopper

4.2 battery and charger

When charging for the first time, please charge the battery for 8-12 hours. Please use unified configuration by the manufacturer of the charger and batteries, standard battery for lithium-ion batteries.

Warning:: this product is battery for lithium-ion batteries contain harmful chemicals and could explode, do not slapped, stabbed it and put on fire.

B: Please recharge the equipment normal work.

4.3 device startup

• Right into the SIM card

L take it outside and turn on open the device key until the indicator light is lit.

L in 10-40 seconds, the device will search for GSM and GPS signals and start working, the LEDs in the normal state of the device will be destroyed after 5 minutes.

• When the device is in the receive the GPS signal correctly, you can use it anywhere in the manual instruction set.

4.3.1 green led: GPRS

4.3.2 blue led: GPS

4.3.3 Red led: power

Note: the green light is not lit display shutdown or Hibernate

Equipment three LEDs, after booting the default display, automatic hibernation after 5 minutes (off light), the device has a call or SMS is to activate the display, automatic hibernation after 5 minutes (off light). In a State of charge, led display not sleep.

4.4 authorization settings

4.4.1 set authorization: sets the Centre number (must be done, you cannot perform other operations)

Must use the owners phone number to Terminal SIM card number to send text messages.

* Text message format is: andmin123456

Receive a prompt ' authorization successful ' message, the owner can SMS commands the terminal operation or car online.

4.4.2 delete authorization

Format: deladmin123456

Reply information: authorize the clearing success

4.4.3 If you need an exotic location, you must ' authorization is required before the mobile number ' plus the country code, for example, sent 'adm123456, 008613322221111' to the device, so 13322221111 is set to become an authorized number.

4.4.4 when the authorization number dialing devices (device SIM card open caller ID), it will revert to a longitude and latitude of real-time information as shown below:

4.4.5 the latitude and longitude information response Description:

Map link: link to open the map for location and links to open-map are not location, range is high, or Baidu, China maps, foreign used Google maps

1.2016-03-18 links to 02:17:53 for the last time when satellite time

2.S:0.0km/h for the device speed

3.Bat:60% battery for your device (range 1-100)

4.ID:4102000759 for the device ID number (used to log on to the platform and APP)

4.5 access device password

Format: APP

Reply information: platform: http://gpsui.NET account number: 100000 password: 123456

Note: the message sent over, approximately 1-2 minutes the device will reply SMS containing account password of the day, if the reply device registration, please wait 5 minutes and try again, or contact the product after-sales service.

4.6 time positioning

4.6.1 if the authorization number is not set, any number of dial devices (open caller ID) it will return the latitude and longitude information; If you have set up your authorization number, non-authorization number dialing devices will not respond to the latitude and longitude information.

Note: the query when the GPS signal is bad, received the latitude and longitude information is finally receiving the latitude and longitude where the signal, if the location of deviations and to look out the latitude and longitude information contained in the information.

4.6.1 SMS query the longitude and latitude information, any number to send commands to the device, will respond to the latitude and longitude information on this number

Format: GPS123456#

Reply to a message:

4.6.2 location in Chinese query

Authorization number to send commands to the device on the SIM card, the device will respond to last location information in Chinese with the authorization number.

Format: DW or 123

Reply information: Shenzhen City, Guangdong Province, baoyuan road, City Road, Tai Yi building (Shenzhen), 63 m

Note: return address required platform support platform in real time online.

4.7SOS monitoring (this feature is the authorization number dialing equipment number equipment near the sound can be heard)

Positioning mode and monitor mode conversion

4.7.1 devices by default for 'tracker' positioning pattern

4.7.2 switch to monitor mode

Instruction formats; monitor123456

Reply to a message; Monitor: a device has been changed to automatically answer calls answer mode setting is successful, call device cards you can hear sounds from equipment.

4.7.3 returned to positioning mode

Format: tracker123456

Reply information: Tracker: equipment for call answer mode has been changed to return location

4.8 electronic fence: this set features recommended Web page platform.

4.9 shift alarm

When the devices are stable 3-10-minute stay in one place, send SMS commands to the device, if the device is out of range, the device will reply to a message, ' vehicle was illegally moved, automatic disarm GPS: + address ' to the authorization number.

4.9.1 alarm settings:

Format: move123456 500

Reply message: Move: successfully set mobile alert, distance 500 m

4.9.2 the device (unlock this feature):

Format: nomove123456

Reply information: Move: successfully canceled shift alarm

Note: range value should be greater than 300 m, automatically turns off after the alarm, such as the need to open you can reset the distance.

4.10 overspeed alarm

4.10.1 alarm settings

Format: speed123456 80 (assuming speed is 80km/h)

Reply information: Speed: successfully set the speed alarm, the alarm speed 80km/h

When the device is running faster than 80km/h, the device will send a message ' you are speeding, please drive safely ' on the authorization number, and sends an alarm message every 5 minutes.

4.10.2 unset: (unlock this feature)

Format: nospeed123456

Reply information: Speed: was cancelled successfully speeding alarm

Note: speeding alarm recommends setting the speed of 50km/h or more, if the speed is too low may result in inaccurate due to GPS signal drift.

4.11 emergency alert (SOS family number, authorization number is valid)

4.11.1 setting SOS number (set 2)

Format: SOS, 138, 139

Reply information: Sos:SOS number: 138, 139

Tightly press the SOS button for 3 seconds, the device will send a text message ' emergency alarm your loved ones or friends for help! Please pay attention! ' To all SOS number.

4.11.2 open SOS function

Format: soson

Reply information: Sos:SOS function is on

Tightly press the SOS button for 3 seconds, the device will send a text message ' emergency alarm your loved ones or friends for help! Please pay attention! ' To all SOS number and dialed the first SOS number.

4.11.3 delete SOS number

Format: QCSOS

Reply information: Sos:SOS number has been cleared

4.12 low power alarm

When the device when the voltage is close to 3.7V, text messages will be sent ' guard your car battery voltage is low, please charge ' to the authorization number.

4.13 vibration alarm

4.13.1 vibration alarm:

Format: shock123456

Reply information: Shock: successfully set the vibration alarm. Alarm message reply

4.13.2 cancellation vibration alarm

Format: noshock123456

Reply information: Shock: to successfully cancel vibration alarm

4.14 real-time online setting

4.14.1 opened online in real time:

Format: hbton

Reply information: Hbt: setting real-time online open

4.14.2 off live online

Format: hbtoff

Reply information: Hbt: real-time online closed

Tip: after you close the real-time online features, mobile APP platform and network device dynamic appears offline, and all of the equipment sets the action (including open real-time online setting) will take effect at the next position report

Note: the modified settings only the authorized number is valid.

4.15 still not set

4.15.1 open static: (factory-device is not switched on by default dynamic report, device power consumption is low, extend the standby time)

Format: nmnron

Reply information: NMNR: still not enabled

4.15.2 close fixed do not report:

Format: nmnrff

Reply information: NMNR: still not reporting prohibited

Tip: open still does not function, when the equipment is stationary, only new jump packs, exercise is only reported location information. After you close the static function, whether stationary or moving equipment in accordance with the time interval reporting location information.

Note: the modified settings only the authorized number is valid

4.16 resetting device tasks

4.16.1 the predecessor task (including the single position, Chinese position, shift speed vibration alarm)

Format: reset

Reply information: all tasks within the device has been reset!

4.17 device restart and recover the factory

4.17.1 restore factory settings

Format: restore

Reply information: device will immediately restore the factory settings, all the previous settings will be cancelled!

Note: only the authorization number is valid, the device will restore the factory settings, all the previous settings will be cancelled.

4.13.2 device restart settings

Format: reboot

Reply information: the device will restart immediately!

5 tips

Please use must be in accordance with:

1. keep the equipment used in a dry environment, damp environment internal circuit damage.

2. Please do not put in too hot or cold place.

3. Please do not rattling device in use.

4. If dirty clean with a dry cloth, do not use chemical agents and cleaners.

5. do not paint the device, this may lead to internal circuit fault.

6. do not disassemble the device.

7. using the factory configuration of the battery and charger. If using other battery and charger may cause some failures.

6 common faults treatment methods