The pump head (without motor)

Bore: 6MM

Can be equipped with motors are available in two ways:

One can carry 57 stepper motor, pitch 46.5MM

Second, can carry 37 DC gear motor, the eccentric shaft and center axes available

Complete system includes a panel mount shell, with a hinged transparent cover, shell is a double roller and a peristaltic pump.
Provided by the individual 12VDC motor (speed range: 8/20/40/85/135rpm ; Maximum flow rates are as follows: 13/32/85/106/220 ml/min)

Elastic rotor structure can maximize the service life of tubes

To change the direction of flow

Black steel noodle soup with pre-drilled mounting plate (High 145mm ' 80mm Wide )Installed between the pump head and the drive motor, to form a complete set of components. If you installed the drive motor and the pump head on the existing panels (from becoming an integral part of equipment), you do not need to use this Board.

Watson Marlow peristaltic pump

Precise extraction liquid at low flow rates, gas and the solution pump. Peristaltic pump operating principle is described in the figure. Three basic operations are: front roller tube closed pipe return suction the fluid. The fluid is inhaled by the next roller block, followed by discharge pump. The pollution-free technology to ensure that fluid or pump, because the fluid is completely contained in the tube; Gentle provides accurate flow rate of the pump and the pump is self priming, so it can air transfer.

Peristaltic pump for laboratory, food processing, beverage preparation, ink and wash, like pharmacy, pharmaceuticals, fermentation and duct mounting fluid available for many other occasions.